User manual OREGON SCIENTIFIC BAA938HG-E

[. . . ] CABLE FREE WEATHER STATION MODEL: BAA938HG USER'S MANUAL INTRODUCTION Congratulations on your purchasing of BAA938HG Top Weather Station. BAA938HG is an all-in-one clock and weather device. It forecasts the weather with kinetic-moving graphic illustrations and gives indoor and outdoor temperature. It also shows a trend indicator and records minimum and maximum temperatures. [. . . ] The display will light up for five seconds with the ALARM ON icon flashing. The crescendo function allows the alarm to start off gently and step up its intensity in three steps. Without interruption, the alarm will go off for 2 minutes. If the SNOOZE/LIGHT button is pressed, the SNOOZE function will be triggered. The alarm will stop and the bell icon blinks for about eight minutes before going off again. CHANNEL SCAN FUNCTION Press and hold CHANNEL button for 3 seconds to enter channel scan function. The readings of each channel will be displayed one by one for 4 seconds automatically. Press any key to stop the scan function. NOTE ON REMOTE TEMPERATURE & HUMIDITY Once batteries are in place for the remote unit, it will start transmitting samplings at 39-43-second intervals. If no signals are received when the remote temperature and humidity is selected, blanks will be displayed. Press and hold the CHANNEL button to enforce a search. This is useful in synchronizing the transmission and reception of the remote and main units. If that fails, check if the remote unit is still in place. Make sure the transmission is within range and path is clear of obstacles and interference. Repeat this procedure whenever you find discrepancies between the reading shown on the main unit and the remote unit. PRE-ALARM FUNCTION FOR CHANNEL 1 REMOTE SENSOR The alarm function also has a pre-alarm feature which can alert the user before the preset alarm time when weather condition changes. This pre-alarm function applies to Channel 1 Remote Sensor only. To enable this function, first activate the alarm function. Then enter the Pre-Alarm mode by pressing the ALARM button twice. The "Pre-Al" icon will be displayed. Press and hold the ALARM button for 3 seconds to set the operating time interval for this pre-alarm function. Use the UP or DOWN button to select from the 4 timeintervals: 15, 30, 45 or 60 minutes. Press the ALARM button to confirm and exit. The pre-alarm function will be enabled automatically which is indicated by the appearance of the [ ] symbol. To disable this function, press the DOWN button in the Pre Alarm mode. [. . . ] Here are a few product care instructions: 1. If the unit comes in contact with water, dry it immediately with a soft lint-free cloth. Do not clean the unit with abrasive or corrosive materials. Abrasive cleaning agents may scratch the plastic parts and corrode the electronic circuit. Do not subject the unit to excessive: force, shock, dust, temperature, or humidity. [. . . ]