User manual OREGON SCIENTIFIC BAR1000A

[. . . ] BA R11 2H GA O T es te d To C o m p ly W ith F C C S t an d a r d s F O R H O M E OR OF F IC E U S E RESET P Q R S T 1 GB GB A . FRONT DISPLAY A four line easy-to-read LCD A1. WEATHER FORECAST WINDOW Graphically illustrates a weather forecast B. [ ] BATTERY-LOW INDICATOR Activates when the remote-sensor or main unit battery power is low C. [. . . ] This is useful in synchronizing the transmission and reception of the remote and main units. Repeat this step whenever you find discrepancies between the reading shown on the main unit and that on the respective remote unit. To display temperature / humidity readings from a remote sensor: · Press [CHANNEL] until the appropriate remote sensor channel is displayed in the box under the kinetic-wave. DISCONNECTED SIGNALS If without obvious reasons the display for a particular channel goes blank, press [CHANNEL] & [MEM] to enforce an immediate search. The remote unit of that channel is still in place. The batteries of both the remote unit and main unit. Note that when the temperature falls below freezing point, the batteries of outdoor units will freeze, which will lower their voltage supply and the effective range. The transmission is within range and path is clear of obstacles and interference. Shorten the distance when necessary. HOW TO CHECK REMOTE AND INDOOR TEMPERATURE & HUMIDITY Display of readings from a remote sensor or the main unit is a onestep procedure. The remote sensor channel or the main unit display is indicated in a box under the kinetic-wave icon. Kinetic-wave Icon Designated Display Indoor Display Remote Remote Display Display Channel 1 Channel 2 Remote Display Channel 3 TRANSMISSION COLLISION Signals from other household devices, such as door bells, home security systems and entry controls, may interfere with those of this product and cause temporary reception failure. This is normal and does not affect the general performance of the product. The transmission and reception of temperature and humidity readings will resume once the interference recedes. To display temperature / humidity readings from the main unit: · Press [CHANNEL] until a dot is displayed in the box under the kinetic-wave. 6 HOW TO READ THE KINETIC WAVE DISPLAY The kinetic wave display shows the signal receiving status of the main unit. There are three possible forms: The unit is in searching mode. Press [HI/LO], Channel-1 will be displayed. Press [ s ] to set the temperature or humidity limit. Each press will increase increments by one degree or percentage. Press and hold the button for a rapid-scrolling sequence by increments of five. Note: The temperature range is from -50°C (-58°F) to +70°C (158°F). If this is the first time you set the limits, the lower limit will start from -50°C (-58°F) and the upper limit +70°C (158°F). Otherwise, the reading will start from the temperature last selected. If this is the first time you set the limits, the lower limit will start from 2% and the upper limit 98%. Otherwise, the reading will start from the humidity last selected. Repeat the steps to set the upper temperature and humidity setting and the lower temperature and humidity settings. When finished, press [HI/LO] to set another limit or wait 16 seconds and the unit will automatically return to the normal 9 GB GB WEATHER FORECAST FUNCTION The unit is capable of detecting atmospheric pressure changes. [. . . ] Do not mix new and old batteries as the old batteries may leak. Read this instruction manual thoroughly before operating the unit. SPECIFICATIONS NOTE ON °C AND °F The temperature display designation of °C or °F on the main display unit will override the display selection made on the remote sensor. Whatever the display unit of the remote sensor is, it will only apply to the remote sensor itself and the temperature unit will automatically be converted to the one of the main unit. °F) Temperature Measurement Main unit Indoor Temperature measurement Proposed operating range Temperature resolution : -5. 0°C to +50. 0°C (23. 0°F to 122. 0°F) : 0. 1°C to (0. 2°F) MAINTENANCE When handled properly, this unit is engineered to give you years of satisfactory service. [. . . ]