User manual OREGON SCIENTIFIC BAR122HGA

[. . . ] GB CAUTION -- The content of this manual is subject to change without further notice. -- Due to printing limitation, the displays shown in this manual may differ from the actual display. -- The contents of this manual may not be reproduced without the permission of the manufacturer. CUSTOMER ASSISTANCE Should you require assistance regarding this product and its operation, please contact our customer care department at 800-853-8883 or via email at helpme@oscientific. com. WARRANTY This product is warranted to be free of manufacturing defects for a period of 1 year from date of retail purchase. Defective product should be directed to the place of retail purchase for exchange. [. . . ] The accuracy of a general pressure-based weather forecast is about 70% to 75%. The weather forecasts from this unit are predictions that cover the next 12 to 24 hours. It may not necessarily reflect the current situation. The "Sunny" icon, implies clear weather. CALENDAR CLOCK DISPLAY MODES The BAR122HGA supports 2 time display modes in the sequence of: MODE 1. Hour-Minute-Second (of local time) Month-Day (of local time) ] (clock) button b122hga-e. p65 10 08/10/2001, 12:17 PM The high-low displays are as follows: Sequence Pressing HI/LO once Pressing HI/LO twice Pressing HI/LO third time Pressing HI/LO fourth time Respective Display Enters HI temperature display Enters HI humidity display Enters LO temperature display Enters LO humidity display display. The respective HI, LO or both indicators will be displayed to signify the status of the alarm. If a channel other than channel-1 is selected, the display will switch to channel-1 and flash when the alarm activates. If left untouched, the alarm will activate for 1 minute. Press either [CHANNEL], [MEMORY], [HI/LO], [ ], [ON/OFF] (TEMP % RH AL) to momentarily stop the alarm. The alarm will activate again if the limit continues to exceed the set limit. Note: If a second limit is passed while an alarm is active, the first alarm will complete its 1-minute cycle and the alarm will continue to activate for a second minute to indicate that a second limit has been surpassed. Enter the setting mode by pressing [HI/LO]. Display will show "---" to indicate such deactivation and will not sound at the previously set limit. To disable a sounding alarm: · Press either [CHANNEL], [MEMORY], [HI/LO], [ ], [ON/OFF] To set a high or low temperature or humidity alarm: 1. Press [HI/LO], Channel-1 will be displayed. Press [ ] to set the temperature or humidity limit. Each press will increase increments by one degree or percentage. Press and hold the button for a rapid-scrolling sequence by increments of five. Note: The temperature range is from -50°C (-58°F) to +70°C (158°F). If this is the first time you set the limits, the lower limit will start from -50°C (-58°F) and the upper limit +70°C (158°F). Otherwise, the reading will start from the temperature last selected. If this is the first time you set the limits, the lower limit will start from 2% and the upper limit 98%. [. . . ] Insert batteries for remote units before doing so for the main unit. Place the main unit as close as possible next to the remote unit, reset the main unit after installing batteries. This will ensure 3 b122hga-e. p65 3 08/10/2001, 12:17 PM GB GB A . FRONT DISPLAY A four line easy-to-read LCD A1. [. . . ]