User manual OREGON SCIENTIFIC BAR623PA

[. . . ] Atomic Projection Clock with Weather Forecast Model: BAR623PA USER MANUAL CONTENTS Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Product Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Front View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press MODE to confirm. 7 EN EN REMOTE SENSOR (THN122N) This product is shipped with a THN122N Thermometer Sensor that collects Temperature data. The main unit can be connected to only 1 remote sensor. Installing the batteries: SET UP SENSOR 1. Open the remote sensor battery compartment with a small Phillips screwdriver. Insert the batteries, matching the polarity (+ and -) as shown in the battery compartment. The switch is located in the battery compartment. Then, press and hold SEARCH on the main unit to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the Data Transmission section for more information. ) 5. Close the remote sensor battery compartment. Secure the sensor in the desired location using the wall mount or table stand. Using the wall mount or stand: 8 For best results: · · · · Insert the batteries and before you mount the sensor. Place the sensor out of direct sunlight and moisture. Do not place the sensor more than 98 feet (30 meters) from the main (indoor) unit. Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture. Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects. Position the sensor close to the main unit during cold winter months as below-freezing temperatures may affect battery performance and signal transmission. remain operational to -20°F with adequate power. Wireless ranges can be impacted by a variety of factors such as extremely cold temperatures. Extreme cold may temporarily reduce the effective range between the sensor and the base station. If the unit's performance fails due to low temperature, the unit will resume proper functioning as the temperature rises to within the normal temperature range (i. e. no permanent damage will occur to the unit due to low temperatures). DATA TRANSMISSION Data is sent from the sensor every 40 seconds. The reception icon shown in the Temperature Area shows the status. ICON DESCRIPTION Main unit is searching for the sensor A Channel has been found --- show in Outdoor Temp Area The sensor cannot be found. [. . . ] Do not use rechargeable batteries with this product. Remove the batteries if storing this product for a long period of time. Do not scratch the LCD display. TROUBLESHOOTING PROBLEM Calendar Clock SYMPTOM Strange date / month Cannot adjust clock Cannot autosynchronize the date and time REMEDY Change language Disable clock 1. Manually activate clock feature Temperature is out-of-range Check batteries Check location Data does not match main unit Initiate a manual sensor search NOTE The technical specification of this product and contents of this user guide are subject to change without notice. [. . . ]