User manual OREGON SCIENTIFIC BAR626-EASY WEATHER STATION

[. . . ] 3 Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Change Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Table Stand or Wall Mount . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 4. Wall mount hole RESET hole CHANNEL number (1-3) Battery compartment (Battery compartment cover not shown) 3 EN EN GETTING STARTED BATTERIES Batteries are supplied with this product: Main unit Remote unit 3 x UM-3 (AA) 1. 5V batteries 2 x UM-4 (AAA) 1. 5V batteries CHANGE SETTINGS To change, time, calendar and language settings: 1. Press and hold MODE for 2 seconds to enter setting mode. (To reach the setting you want quickly, press and hold or . ) 3. Press MODE to confirm. Insert batteries before first use, matching the polarity (+ and -) as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. NOTE It is recommended that you use alkaline batteries with this product for longer performance. TABLE STAND OR WALL MOUNT Use the stand on the back of the main unit / remote sensor, or mount it on a wall with a nail. Attaching the stand: Installing the batteries: Using the wall mount: UNIT Main Remote LOCATION Indoor Temperature Area Outdoor Temperature Area Using the remote sensor stand or wall mount: 4 REMOTE SENSOR (THN122N) This product is shipped with a THN122N Thermometer Sensor that collects Temperature data. Data can be collected from up to 3 sensors. Additional sensors sold separately. ¥ Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects. ¥ Position the sensor close to the main unit during cold winter months as below-freezing temperatures may affect battery performance and signal transmission. You may need to experiment with various locations to get the best results. SETUP SENSOR DATA TRANSMISSION 1. Open the remote sensor battery compartment with a small Phillips screwdriver. Insert the batteries, matching the polarity (+ and -) as shown in the battery compartment. If you are using more than one sensor, select a different channel for each sensor. Data is sent from the sensor(s) every 40 seconds. The reception icon shown in the Temperature Area shows the status. ICON DESCRIPTION Main unit is searching for sensors. Channel 1 is selected (number will change depending on the sensor you select). 3. The switch is located in the battery compartment. Then, press and hold MEM and CHANNEL on the main unit to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the Data Transmission section for more information. ) 5. Close the remote sensor battery compartment. [. . . ] Indoor data is collected and displayed every 10 seconds. SELECT TEMPERATURE UNIT Waning Gibbous Slide the °C / °F switch into the desired location. The switch is located in the main unit battery compartment. The setting for the main unit overrides the remote sensor setting. Last Quarter Waning Crescent SELECT CHANNEL NUMBER RESET SYSTEM Press CHANNEL to switch between sensors 1-3. Manually activate clock feature ( 6) Temperature is out-of-range Check batteries ( Check location ( Check sensors. [. . . ]