User manual OREGON SCIENTIFIC BAR636A

[. . . ] Open the remote sensor battery compartment with a small Phillips screwdriver. Insert the batteries, matching the polarity (+ and -) as shown in the battery compartment. CLOCK The clock automatically synchronizes the current time and date when it is brought within range of the WWVB-60 atomic clock signal generated from Fort Collins, Colorado. For more information, please visit: www. boulder. nist. gov/timefreq/ stations/>radioclocks. htm NOTE The signals are collected by the main unit when it is within 932 miles (1500 km) of a signal. Initial reception takes 2-10 minutes, and is initiated when you first set up the unit, and whenever you press RESET. [. . . ] SET CLOCK / CALENDAR You only need to do this if you have disabled the atomic clock feature (for example, if you are too far from or cannot receive a signal). Select the time zone, hour, minute, year, month, day, or to and day of the week language. The time zone options are PA (Pacific), MO (Mountain), CE (Central) and EA (Eastern). The language options are (E) English, (F) French, (D) German, (I) Italian, and (S) Spanish. 1. 4. Wall mount hole RESET hole CHANNEL number (1-3) Battery compartment (Battery compartment cover not shown) GETTING STARTED BATTERIES Main unit Remote unit 3 x UM-3 (AA) 1. 5V batteries 2 x UM-4 (AAA) 1. 5V batteries SWITCH CLOCK DISPLAY Press MODE to toggle between Clock with Seconds and Clock with Weekday display. Insert batteries before first use, matching the polarity (+ and -) as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. NOTE It is recommended that you use alkaline batteries with this product for longer performance. Installing the batteries: ALARMS This product is equipped with a 2-minute crescendo alarm. VIEW ALARM SETTINGS DATA TRANSMISSION Data is sent from the sensor(s) every 40 seconds. The reception icon shown in the Temperature Area shows the status. The alarm time and alarm status will show in Press the Clock Area. SET ALARM 1. Battery compartment (cover off) ICON DESCRIPTION Main unit is searching for sensors. Channel 1 is selected (number will change depending on the sensor you select). --- shows in Outdoor Temp Area The selected sensor cannot be found. Search for the sensor or check batteries. Press to confirm. LCD DISPLAY ACTIVATE ALARM Press to activate or deactivate the alarm. shows in UNIT Main Remote LOCATION Indoor Temperature Area Outdoor Temperature Area the Clock / Alarm Area when the alarm is activated. SILENCE ALARM When the alarm time is reached, the crescendo alarm will sound for 2 minutes. To silence the alarm: SEARCH FOR SENSOR CHANGE SETTINGS To change, time, calendar and language settings: 1. Press and hold MODE for 2 seconds to enter setting mode. (To reach the setting you want quickly, press and hold or . ) 3. To search for a sensor, press and hold MEMORY and CHANNEL (on the main unit) for 2 seconds. NOTE If the sensor is still not found, check the batteries, obstructions, and remote unit location. · Press SNOOZE to silence it for 8 minutes. OR · Press any key except SNOOZE to mute the alarm and activate it again after 24 hours. [. . . ] Oregon Scientific will not be responsible for any deviations in the usage of the device from those specified in the user instructions or any unapproved alterations or repairs of the product. Observe the following guidelines: · Never immerse the product in water. This can cause electrical shock and damage the product. · Do not subject the main unit to extreme force, shock, or fluctuations in temperature or humidity. [. . . ]