User manual OREGON SCIENTIFIC BAR686A

[. . . ] Make sure you use a different channel for each sensor. Simultaneously press CHANNEL and MEM on the main unit to initiate signal sending between the sensor and main unit. Close the battery door and secure the screws. Place the sensor in the desired location using the table stand or wall mount. To enable and force a signal search: Press and hold for 2 seconds. [. . . ] -" (Outdoor temperature area) The sensor cannot be found. Search for the sensor or check batteries ALARM To set the alarm: 1. Press ALARM again to turn alarm ON / OFF. To silence the alarm: · Press SNOOZE to silence it for 8 minutes. OR · Press any key except SNOOZE to turn the alarm off and activate it again after 24 hours. GETTING STARTED SETTING UP THE CLOCK Insert batteries before first use, matching the polarity (+ and -). RESET after each battery change. WEATHER FORECAST This product forecasts the next 12 to 24 hours of weather within a 30-50 km (19-31 mile) radius based on barometric pressure trend readings. ICON DESCRIPTION Clear Partially Cloudy Cloudy indicates main unit batteries are low. We recommend that you use alkaline batteries with this product for longer usage and lithium batteries in temperatures below freezing. 1. 9. / : Increase / decrease setting; activate / deactivate clock reception signal CHANNEL: Switch remote sensor display MODE: Change settings / display ALARM: View alarm status; set alarm Battery compartment TEMP HI / LO : Change settings or enable / disable hi or lo temperature alarm for channel 1 °C / °F: Select temperature unit MEM: View current, maximum and minimum temperature / humidity RESET: Reset unit to default settings REMOTE SENSOR The sensor collects temperature readings approx. every 40 seconds and sends them to the main unit. The main unit can collect data from up to 3 sensors. Remove the screws from the battery door. Insert the batteries, matching the polarity (+ / -). To search for a sensor: Simultaneously, press and hold MEM and CHANNEL for 2 seconds. NOTE If the sensor is still not found, check the batteries, obstructions, and remote unit location. Rainy BAR686_M 1 2005. 12. 2, 2:31 PM TEMPERATURE To toggle temperature unit: Press °C / °F. To view outdoor sensors temperature readings: Press CHANNEL. To auto-scan between sensors: Press and hold CHANNEL for 2 seconds. Each sensor's data is displayed for 3 seconds. To toggle between current, minimum and maximum records for the selected sensor: Press MEM repeatedly. To clear the records: Press and hold MEM for 2 seconds. · Do not clean the unit with abrasive or corrosive materials. · Do not tamper with the unit's internal components. Doing so will invalidate the warranty on the unit and may cause unnecessary damage. The unit contains no user-serviceable parts. [. . . ] Use and to select high / low temperature alarm. Press / to set alarm ON / OFF and press TEMP HI / LO to confirm. If alarm has been activated, use and to select the temperature. To silence the hi / lo temperature alarm: Press any key. [. . . ]