User manual OREGON SCIENTIFIC BAR898HGA

[. . . ] LONG-RANGE WIRELESS WEATHER STATION WITH IN-OUT THERMO-HYGROMETER AND RF CLOCK MODEL : BAR898HGA USER'S MANUAL INTRODUCTION Congratulations on your purchase of the BAR898HGA LongRange Wireless Weather Station with In-Out Thermo-Hygrometer and RF Clock. This unit is an all-in-one weather forecasting device which has multiple weather-related functions. Also, with an internal antenna the reception range of this unit can be up to 100 meters. The BAR898HGA, a weather forecasting device, has several weather related functions. [. . . ] Enter the appropriate month using the UP [ ] or DOWN [ ] button. Press [MODE] button and the day settings will flash. Enter the appropriate day using the UP [ ] or DOWN [ ] button. Press [MODE] again and the language setting will flash. Use the UP [ ] or DOWN [ ] button to select E for English, F for French or S for Spanish. Press [MODE] to complete and exit the setting. The weekday can be expressed as an abbreviation in three different languages. The languages and their selected abbreviations for each day of the week are shown in the language chart below. Day-of-the-week Language Monday Tuesday W e d . Thursday Friday Saturday S u n d a y Good No signal Receiving HOW TO MANUALLY SET THE CLOCK Press [MODE] and hold for three seconds. Use the UP [ ] or DOWN [ ] button to enter the hours. Holding down either the up or down button will increase or decrease the value rapidly. Press [MODE] again, the minute will flash. Again, use the UP [ ] or DOWN [ ] button to change the minutes. 7 English French Spanish To toggle among the 4 U. S. time-zones, press the [ZONE] button. GB GB HOW TO SET AND ACTIVATE THE ALARM To set the Alarm Press [ALARM] button to display the daily alarm time (the icon " " will be displayed) Press [ALARM] and hold for three seconds, the value for the hour will flash. Press UP [ ] or DOWN [ alarm hour setting. ] buttons to make changes to the To stop the alarm, press the [ALARM] button. However, if [ SNOOZE / LIGHT ] is pressed, the SNOOZE function will be triggered. The alarm will stop and the ALARM ON icon blinks for eight minutes. To deactivate the SNOOZE function, press the [ALARM] button. CHECKING INDOOR AND REMOTE TEMPERATURES & HUMIDITIES To display the indoor and outdoor temperature and humidity readings, press the [CHANNEL] button to toggle among the indoor, Channel 1, 2 and 3 displays. The temperature can be shown in Centigrade (°C) or Fahrenheit (°F). Select the appropriate reading by using the °C/°F slide switch (located in the battery compartment). [. . . ] Doing so will terminate the unit's warranty and may cause damage. The unit contains no user-serviceable parts. 12 Relative Humidity measurement Measuring Range Humidity Resolution : 25% RH to 95% RH at 25°C (77°F) : 1% RH Remote unit RF Transmission Frequency : 433 MHz No. of Remote unit RF Transmission Range Data sensing cycle : Up to 3 units : Up to 100 meters or 300 feet : around 40 seconds Temperature measurement Display range Proposed operating range Temperature resolution : -20. 0°C to +60. 0°C (-4. 0°F to 140. 0°F) : -5. 0°C to +60. 0°C (23. 0°F to 140. 0°F) : 0. 1°C (0. 2°F) Dimensions Main unit Remote sensing unit : 195 (L) x 105 (W) x 77 (T) mm or 7. 68 x 4. 13 x 3. 03 inches : 105 (L) x 70 (W) x 21 (T) mm or 4. 13 x 2. 76 x . 83 inches Relative Humidity measurement Measuring Range Humidity Resolution : 25 to 90%RH at 25°C (77°F) : 1% RH CAUTION -- The content of this manual is subject to change without further notice. [. . . ]