User manual OREGON SCIENTIFIC BAR928

[. . . ] What is more, the BAR928 is equipped with a moon phase scanner, which lets you check the moon phase of any day between 1990 and 2089. Other features include a HiGlo backlight, daily crescendo alarm with eight-minute snooze function, and extra-large display. No wire installation is required between the main and remote units. As the BAR928 operates at 433MHz, it can be used in the U. S. [. . . ] The E, I, D, F or S language indicator will flash. Use the UP or DOWN button to select E for English, I for Italian, D for German, F for French or S for Spanish. · Press MODE. Use the UP or DOWN button to enter the day and press MODE again to confirm and exit. 3 GB GB MULTILINGUAL DAY-OF-THE-WEEK The display language of the day-of-the-week is selected in the calendar setting procedure. The foreign languages and their meanings are as follows: NOTE ON OUTDOOR-REMOTE TEMPERATURE Once batteries are in place for the remote unit, it will start transmitting samplings at 30-second intervals. If no signals are received when the outdoor-remote temperature is selected, blanks will be displayed. Press and hold the THERMO button to enforce a search. This is useful in synchronizing the transmission and reception of the remote and main units. German If that fails, check if the remote unit is still in place. Make sure the transmission is within range and path is clear of obstacles and interference. Repeat this procedure whenever you find discrepancies between the reading shown on the main unit and the remote unit. NOTE ON °C AND °F HOW TO SET AND ACTIVATE THE ALARM When the alarm time is displayed, press and hold ALARM for three seconds. Press ALARM to confirm and go to the minute digits. Enter the value and press ALARM to confirm. To deactivate it, press ALARM once when the alarm time is displayed. Then use the UP or DOWN button to toggle its status. The outdoor temperature display on the main unit is dominated by the selection on the °C/°F slide switch of the main unit. Whatever the display unit of the remote sensor is, it will only apply to the remote sensor itself and the temperature will be automatically converted to the chosen one of the main unit. MAXIMUM AND MINIMUM TEMPERATURES The maximum and minimum recorded temperatures will be automatically stored in memory. To display them, press MEMORY to rotate through the maximum, minimum and current temperatures. The respective MAX or MIN indicator will be displayed. To clear the memory, hold down MEMORY for three seconds. The maximum and minimum temperatures will be erased. If you press MEMORY now, the maximum and minimum temperatures will have the same values as the current one until different readings are recorded. ALARM AND SNOOZE FUNCTION When the alarm is active, it will go off at the set time. The display will light up for five seconds with the ALARM ON icon flashing. The crescendo function allows the alarm to start off gently and step up its intensity in three steps. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: o Reorient or relocate the receiving antenna. o Increase the separation between the equipment and receiver. [. . . ]