User manual OREGON SCIENTIFIC BAR938HGA

[. . . ] Cable Free Weather Station with Thermo-Hygrometer and Radio controlled clock MODEL: BAR938HGA USER'S MANUAL INTRODUCTION Congratulations on your purchasing of BAR938HGA Cable Free Weather Station with Thermo-Hygrometer and Radio controlled clock. RF- controlled, BAR938HGA can automatically synchronize its current time and date when it is brought within range of the radio signal generated from the U. S. BAR938HGA does weather forecasts with kinetic-movement graphic illustrations and tells indoor and outdoor temperature. It also shows the trend of changes plus the recorded maximum and minimum temperatures. [. . . ] When the alarm is active, it will go off at the set time. The display will light up for five seconds with the [ ] icon flashing. Without interruption, the alarm will go off for 1 minute. To stop the alarm, press [ALARM], [MODE], [LIGHT], [ [ ] or [ZONE] button. ], NOTE ON °C AND °F The outdoor temperature display on the main unit is dominated by the selection on the °C/°F slide switch of the main unit. Whatever the display unit of the remote sensor is, it will only apply to the remote sensor. The temperature display on the main unit will be automatically converted to the chosen one on the main unit. MAXIMUM AND MINIMUM TEMPERATURES & HUMIDITY The maximum and minimum recorded temperatures and humidity will be automatically stored in memory. To display them, press MEMORY to toggle among the maximum, minimum and current temperatures and humidity. The respective MAX or MIN indicator will be displayed. To clear the memory, hold down MEMORY for three seconds. The maximum and minimum temperatures and humidity will be erased. If you press MEMORY now, the maximum and minimum temperatures and humidities will have the same values as the current one until different readings are recorded. HOW TO CHECK INDOOR AND OUTDOORREMOTE TEMPERATURES & HUMIDITIES To display indoor temperatures and humidities, press the CHANNEL button until the [ ] indicator lights up. To display outdoor-remote temperatures and humidities, press the CHANNEL button to scroll through the readings from up to 3 remote sensors. The temperature can be shown in Centigrade (°C) or Fahrenheit (°F). The unit is selected on the °C / °F slide switch. If the readings go above or below the specified range, the display will show flashing "HHH" or "LLL". TEMPERATURE AND HUMIDITY TREND The temperature trend and humidity trend indicators show the trend of collected readings. Three trends rising, steady and falling, will be shown. Arrow indicator Temperature Trend Rising Steady Falling CHANNEL SCAN FUNCTION Press and hold CHANNEL button for 3 seconds to enter channel scan function. The readings of each channel will be displayed automatically, one by one, for 4 seconds. Press CHANNEL again to stop the scan function. Arrow indicator Humidity Trend Rising Steady Falling NOTE ON REMOTE TEMPERATURE & HUMIDITY Once batteries are in place for the remote unit, it will start transmitting samplings at 39-43-second intervals. If no signals are received when the remote temperature and humidity is selected, blanks will be displayed. Press and hold the CHANNEL and MEMORY buttons together to enforce a search. This is useful in synchronizing the transmission and reception of the remote and main units. [. . . ] Do not tamper with the unit's internal components. Doing so will terminate the unit's warranty and may cause damage. The unit contains no user-serviceable parts. Only use new batteries as specified in this instruction manual. [. . . ]