User manual OREGON SCIENTIFIC BARM123A

[. . . ] Multi digital clock radio with soothing sounds MODEL: BARM123A USER'S MANUAL INTRODUCTION BARM123A is a multi-functional device with: Digital-tuning AM/FM Radio Auto-synchronizing Radio Controlled Clock by radio signal from the U. S. Atomic Clock Indoor and Remote Thermometer with memories for Maximum and Minimum readings Weather Forecaster with Pressure Trend Indicator Soothing Sounds with a choice of 6 natural sounds T7. [AM/FM] button Press to toggle between AM or FM radio band Press to increase the frequency setting when Radio is On Press and hold for 2 seconds to trigger radio auto-search function when Radio is On Press to decrease the frequency setting when Radio is On Press and hold for 2 seconds to trigger radio auto-search function when Radio is On T8. [TUNING w] button - PACKAGE In the package you will find the following items: 1 x Main Unit (BARM123A) 1 x Remote Thermo Sensor (THR268) with wall mount bracket & table stand 1 x Detachable Vibrating Alarm 1 x 8 V AC/DC Adapter FRONT KEY PANEL F1. [. . . ] Again, select the radio volume by using [VOLUME v] or [VOLUME w]. Press [ALARM] to confirm the entry and exit the setting mode. The respective Alarm settings will be updated once any value is changed in the above setting modes. To enable/disable the alarm, press [ALARM ON/OFF the main unit is in such Alarm display mode ] when This unit is equipped with 2 daily alarms. To view the preset alarm time(s), press [ALARM] to toggle between ALARM 1 and ALARM 2 display modes. To set the corresponding alarm time(s), follow the instructions below: 1. Press and hold [ALARM] for 2 seconds in ALARM 1 or ALARM 2 display mode. The display will enter the corresponding alarm setting mode and the hours will blink. Enter the hour by using [VOLUME v] or [VOLUME w]. Enter the minutes by using [VOLUME v] or [VOLUME w]. The beep alarm or radio alarm icon will blink. Select the alarm-sounding mode by using [VOLUME v] or [VOLUME w]. In Beep alarm mode, a 2-minute crescendo alarm will be turned on when the alarm time is up. In Radio alarm mode, when alarm time is up, the radio will be turned on and remained on for 2 hours until it is manually deactivated. In Vibrating Alarm mode, the Vibrating alarm will be turned on for 2 minutes when the alarm time is up. Note: When the Vibrating alarm is connected to the unit, the Vibrating alarm mode will be automatically selected and the Vibration icon will light up. ( ON ) ( OFF ) When [SNOOZE] is pressed to stop the alarm sound (only when Beep Alarm or Vibration Alarm mode is selected), the unit will re-alarm again after 8 minutes. To disable the snooze function, press [ALARM] or [ALARM ON/OFF ]. Insert batteries or press the reset button of the main unit. Replace the battery compartment door and secure its screws. Position the remote sensor and main unit within effective transmission range, which in usual circumstances, is 80 meters or 240feet. Though the sensor is weather resistant, and is meant for use outside, it should be placed away from direct sunlight, rain, or snow. Note: The effective range may be limited by building materials and the position of either the main unit or remote sensors. [. . . ] Arrow Indicator Pressure Trend PRECAUTIONS This unit is engineered to give you years of satisfactory service if handled with care. Do note clean the unit with abrasive or corrosive materials. Do not subject the unit to snow or excessive force, shock, dust, temperature or humidity. Do not tamper with the unit's interal components. [. . . ]