User manual OREGON SCIENTIFIC CP600

[. . . ] - User key option for Count Down Stop or Count Down Repeat mode. - HiGlo back light with 3 seconds delay. GENERAL OPERATION SEQUENCES S4 S1 S3 S2 - Press S3 to advance through the various watch function as shown below: S4 TIME & CALENDAR S3 ALARM CALIBRATION S3 S3 CHRONOGRAPH S3 TIMER S3 COMPASS S2 S2 Press & hold ELECTRONIC COMPASS After activate the Compass function, the Current direction is shown. CALIBRATION Calibration allows user to align the watch magnetic sensor with the earth's magnetic field so that the watch can detect correct direction. [. . . ] - Press S4 to activate the Compass function. - Press S3 to return back to Normal Time mode. If there is no key operation for 30 seconds, the watch will return back to Normal Time mode automatically. Cautious: The Compass watch is very sensitive to magnetic and electric fields. The direction will be affected by nearby magnet or electric devices. NORMAL TIME Normal Time mode presents hour, minute, second, month, date and weekday. For 12Hr display format, "A" or "P" flag will be displayed. Weekday Month Date S4 S1 S4 S1 S3 12Hr Format S2 S3 24Hr Format S2 SETTING NORMAL TIME - Press S3 to Normal Time mode. - Press & hold S2 to enter the Normal Time Setting mode, then the "SECOND" digits start flashing. - Press key S1 to reset the "SECOND" digits to "00". When the seconds digits count between 30 to 59 and key S1 is pressed, the seconds are reset to 00 and one minute is added. - Press S2 to select next digits for setting. The setting sequence is shown as follow: 2 SECOND S2 S2 HOUR S2 MINUTE S2 MONTH S2 12H/24H S2 WEEKDAY S2 DATE - Press S1 to forward setting digits. - Press S3 to exit the setting mode and return to normal. ALARM TIME MODE Alarm Time mode presents Alarm hour and Alarm minute. The alarm sounds at the alarm time everyday if the alarm mark is armed. Press any key while alarm sound is active to stop the alarm sound without activate other function. "Beep-Beep" sound is generated every hour if the Chime mark is armed. Alarm mark S4 S1 Chime mark S3 S2 AM/PM SETTING ALARM TIME - Press S3 to Alarm Time mode. - Press S2 to enter setting mode, then Hour digit start flashing. [. . . ] The working range of the timer is 60 minutes and the resolution is 1 second. - Press S1 for start/stop operation. S4 S1 S4 S1 S3 COUNT DOWN STOP S2 S3 S2 COUNT DOWN REPEAT SETTING TIMER - Press S3 to Timer mode - Press S1 for start/stop operation. - Press S2 while the timer is in stop mode for setting timer. - Press S1 to forward the setting digit. [. . . ]