User manual OREGON SCIENTIFIC DS3868

[. . . ] Important: Do not mix old batteries with new batteries. Always dispose of exhausted batteries properly. Do not insert anything except batteries into the battery compartment as this may cause damage to the camera. After the camera is turned on, select the desired camera mode. The mode selections are: Standby, Normal, Continuous Capture, Self Timer, Clear Photos and Resolution Setting. [. . . ] The F PHOTO COUNTER will decrease by a value of one with each photo taken. When a photograph is taken, a single short beep will be emitted. After the beep sounds, the camera is ready to take another photograph. Important: When the maximum number of photos have been taken, F the PHOTO COUNTER will show "00. " If G CAPTURE is pressed when "00" is displayed, a series of short beeps will sound indicating that the maximum number of photographs have been taken. The photographs must be downloaded or cleared from the camera before more photographs can be taken. (See Downloading Photographs. ) Note: The DS-3868 will not take photos in low light conditions. When the light is too low for the DS-3868, a beep will be emitted when photo is attempted. I J Bottom View K Top View Connecting the Camera to Your PC 3. H Standby Normal/ High Resolution Continuous Capture Self Timer 1. Connect and install the H USB Cable (included) to the USB port of your PC. Open the I Camera Connection Cable Door and plug the cable into the PC Interface Jack. Install the ArcSoft® software (included) on your PC. Follow the instructions for downloading photographs. The DS-3868 has video streaming capability. Screw the J DS-3868 securely to the K mini-stand. Position the camera where the L Front-View Viewfinder is facing the subject. Follow instructions provided in the Windows Netmeeting software for video conferencing function. Press the E MODE button to sequence through the camera modes High Resolution Low Resolution Clear Photos dh9/20/00 DS3868 Manual(ver. 1)/OSI-USA ¶´ 1 4/10/01, 10:09 am Installing the Software 1. Make sure that no programs, such as games or anti-virus software, are running on the PC. If programs are open, close and exit from the programs before going on to step 2. Insert the ArcSoft® CD-ROM into the CD-ROM drive of the PC. After a short period, a setup menu will appear on the PC screen. From the setup menu, choose what language you want the setup instructions to be in. After highlighting your selection, click OK. Follow the on-screen instructions to install the software. [. . . ] Open the ArcSoft® software and from the main menu select and click on "Photo Base" to open. From the "Photo Base" menu, click on "Acquire" (the camera icon). Select "Oregon Scientific" and click "Select. " 4. The photos will be displayed on the screen in thumbnail form. [. . . ]