User manual OREGON SCIENTIFIC HMS388

[. . . ] Music Element 2. 1 CD Micro System Model: HMS388 User Manual HMS388 Eng Cover R27 OP 1 7/30/05, 11:08 AM IMPORTANT SAFETY INSTRUCTIONS The Music Element 2. 1 CD Micro System is designed to give you years of service if handled properly. Ensure that you heed all warnings to minimize product malfunction and reduce the chances of incurring personal injury. Before using the unit, observe the following guidelines to ensure proper care and maintenance. WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTEDTO PREVENT BLADE EXPOSURE. [. . . ] ADDITIONAL CONNECTIONS (OPTIONAL) AUXILIARY At the back of the unit are Aux (Auxiliary) in / Audio out jacks, allowing for connections to additional audio systems or speakers. Simply connect the appropriate cable wires to the jacks of the audio system. Operate the unit and additional devices as normal. NOTE Aux feature can be controlled from the remote control only, not from the unit itself. EARPHONES Similarly, while the slim speakers and subwoofer provide crystal clear audio playback, you may optionally connect earphones to the earphone jack at the back of the unit and listen to audio at your own convenience and without disturbing others. BASIC OPERATIONS NOTE References to "CD" or "disc" includes both audio CDs and MP3 / WMA CDs unless otherwise noted. To adjust the system clock, power off the unit so that it is in standby mode. The clock minutes will flash on the unit's VFD. Press the - / + button on the unit to adjust the minutes by 1-minute increments. Press the - / + button on the unit to adjust Press the the minutes by 1-hour increments. Press the / button to confirm the desired clock setting. 10 HMS388 Eng R27 OP 10 7/30/05, 11:08 AM NOTE This unit operates on a 24-hour clock only. A 12-hour clock with AM / PM display is not available with this unit. NOTE If the unit is idle for 30 seconds (that is, no buttons are pressed on the unit or remote control), the clock will return to the previously set time. If you were in the middle of setting the clock and you decide to quit, press any button on the unit or remote control. Press the Press the button to turn the system on. button on the unit to open the CD lid and insert or replace a disc into the CD tray. button to close the lid. The system Press the area near the centre hole of the disc until it clicks into position, press the will automatically show the CD status on the VFD, which includes total number of tracks and play time of the disc just inserted. PLAYBACK 1. If the CD does not start playing automatically, press the button on the unit or remote control to start playback. When a particular track of the inserted CD is playing, the corresponding track number and track time will show on the unit's VFD. Press the button on the unit or remote control to pause playback. The Play LED indicator and track number and track time shown on the VFD will flash. To resume playback, press the or button. or button on the unit or the / tune+ or / tune- button on the To select another track during playback, press the remote control to select the desired track. [. . . ] A preset station may not have been saved properly if you were manually tuning stations. Try again and ensure that the station chosen exhibits a strong reception signal. Check the battery is loaded correctly with the correct polarity. If it is low on power or exhausted, replace the battery. [. . . ]