User manual OREGON SCIENTIFIC JOHN DEERE RAR232

[. . . ] Clock and calendar display modes . . . . . . . . . . . . . . . . . . . . . . . . Set time / date / language . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Set alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Indoor and outdoor temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press RESET on the main unit to begin synchronization. 2. Install the main unit batteries. 5 RAR232A-E CP5. P65 5 10/4/05, 11:29 AM EN EN KINETIC WAVE DISPLAY The kinetic wave display shows the signal reception status of the main unit. There are three possible outcomes: Searching for signal. For best results: · Place the unit away from electrical or mechanical objects. · Place the unit out of direct sunlight and moisture. · Do not place the remote unit more than 100 feet (30meters) from the main unit. · Position the remote unit so that it faces the main unit. · Minimize obstructions such as doors, walls, and furniture. You may need to experiment with various locations to get the best reception. NOTE Signals from other household devices, such as doorbells, home security systems and entry controls, may interfere with this product's signals and cause temporarily reception failure. This is normal and does not affect the general performance of the product. The transmission and 6 RAR232A-E CP5. P65 6 reception of temperature readings will resume once the interference recedes. Upon successful reception: · The top line will display outdoor temperature. · The bottom line will display indoor temperature. NOTE When the temperature falls below freezing, an alkaline battery in the outdoor unit may freeze, lowering the voltage supply and the effective range. If no signals are received, blanks " " will be displayed and the kinetic wave icon will show " ". Press and simultaneously to force a 4 minute search. This will reestablish transmission and reception for the remote and main unit. 10/4/05, 11:29 AM Repeat this step whenever you find that the temperature displayed on the remote sensor is not the same as the outdoor temperature display on the main unit. CLOCK AND CALENDAR DISPLAY MODES The clock and calendar share the same section of the display. The calendar is displayed in a day-month format. Press the MODE button to toggle between clock and calendar display modes. TIP: During setting, press and hold increase or decrease a value. or to rapidly . NOTE The date is displayed in DAY-MONTH format. For the display language, you can choose from English (E), German (D), French (F), Italian (I), or Spanish (S). SET ALARM To set the alarm: 1. If the alarm is disarmed, the time will be displayed as . [. . . ] Unauthorized changes may void your right to use the product. · The technical specifications for this product and the contents of the user guide are subject to change without notice. · Images not drawn to scale. Dimension Main unit: Remote sensing unit: Main unit (indoor temp) Operating range: Resolution: Remote unit (outdoor temp) Operating range: Resolution: No. of remote unit: RF transmission range: -4°F TO 140°F (-20°C to +60°C) 0. 2°F (0. 1°C) 1 100 feet (30 meters) 23°F to 122°F (-5°C to +50°C23) 0. 2°F (0. 1°C) 113(L) x 54(W) x 62(T) mm 96(L) x 50(W) x 28(T) mm RF transmission frequency: 433 MHz Temperature sensing cycle: Approx. [. . . ]