User manual OREGON SCIENTIFIC MTR101-E

[. . . ] [MEM] BUTTON Displays current, maximum and minimum temperatures 1 °C °F RESET D J E H I GB GB F. RESET BUTTON Returns all settings to default values G. °C/°F SLIDE SWITCH Selects between degrees Centigrade (C) and Fahrenheit (F) H. [. . . ] The main unit will automatically update its readings at 30-second intervals. If no signals are received, blanks will be displayed. Press CHANNEL and MEM simultaneously to enforce an immediate search. This is useful in synchronizing the transmission and reception of the remote and main units. Kinetic-wave Icon Designated Display Remote Display Channel One Remote Display Channel Two Remote Display Channel Three To start an automatic scan on all channels, press and hold CHANNEL for two seconds. The main unit will scan from one channel to another and back. The reading for individual channel will be displayed for five seconds. Press any key to end the automatic scan. The MTR101 is capable of measuring temperatures within the -50°C (-58°F) and +70°C (+158°F) range. If the temperature goes above or below that, the display will show "HHH" or "LLL". INDOOR AND OUTDOOR TEMPERATURES The indoor temperature is shown on the secondary display. As for the remote sites or channels, press CHANNEL repeatedly to go from one channel to another. The kinetic wave display on the channel number indicates the reception of that particular channel is in good order. MAXIMUM AND MINIMUM TEMPERATURES The maximum and minimum recorded indoor temperatures and those of each channel will be automatically stored in memory. Press [CHANNEL] to locate the desired channel. Press [MEM] repeatedly to display the current, maximum (MAX) and minimum (MIN) temperatures. The readings of the indoor temperatures will also be displayed. 4 To clear the memory of a particular channel, 1. Press [CHANNEL] to locate the desired channel. Note it will also erase the memory for the indoor temperatures. If you press MEM now, the maximum and minimum temperatures will have the same values as the current ones until different readings are recorded. HOW TO USE THE TABLE STAND OR WALL MOUNTING Turn the table stand knob out to place the main unit on a flat surface. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. [. . . ]