User manual OREGON SCIENTIFIC PMP238

[. . . ] Battery Compartment - One (1) CR2032 3V lithium cell FEATURES 1. Pillbox storage User select 12 or 24-hour clock Pulse monitor Countdown timer Timer alarm 12 /24 hr. real-time clock GB GB GETTING STARTED Battery is included. Please pull the protective insulation tape out with a firm pull to start your pmp238. [. . . ] To adjust the "seconds" to zero, press [ 10. Note: If no buttons are pressed for 60-seconds during the clock-setting function, the unit will automatically exit the clock-setting mode. ADV]. THE TIMER The timer can count down from a pre-set time. The unit will count down from a maximum time of 29-hours, 59-minutes to zero. In count-down timer mode, once the unit reaches zero it will stop and an alarm will sound. To indicate that the unit is in timer mode a [ will be displayed . Note: If the clock is displayed, press [MODE] to enter the timer mode. From pulse mode, press [PULSE] to exit followed by [MODE] to toggle between clock and timer displays. To set the timer, press and hold [MODE] for 2 seconds. Press [ ADV] to advance the hour digits to the desired time. Press [MODE] and the minute digits will flash. 5. Press [ ADV] to advance the minute digits to the desired time. Note: If no buttons are pressed for 60-seconds during the timer-setting function, the unit will automatically exit the timer-setting mode. Note: - When the timer reaches 0:00:00 a beeping alarm will activate to indicate that the timer has completed its cycle. After one minute, the alarm will continue to make one short beeping sound once every two-minutes. To stop the alarm, press any button and the timer will automatically reset to the original timer setting. - When the timer is active, the timer icon will appear and be flashing on the pulse-mode display and the clock display. The timer will pause until [ST / SP] is pressed again. To clear the timer: 1. The digits will return to zero and the hour digits will flash. Without entering a number for the hours, press [MODE] again. Press [MODE] a final time to exit the timer-setting mode. To reset the timer to its originally set time: - Press and hold [ST / SP] for 2-seconds. [. . . ] Only use new batteries as specified in this instruction manual. Read this instruction manual thoroughly before operating the unit. CAUTION -- The content of this manual is subject to change without further notice. -- Due to printing limitation, the displays shown in this manual may differ from the actual display. -- The manufacturer and its suppliers held no responsibility to you or any other person for any damage expenses, lost profits, or any other claim arise by using this product. [. . . ]