User manual OREGON SCIENTIFIC PSR01

[. . . ] Getting started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Set up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Change channel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Comfort zone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Place remote unit as close as possible to the main unit. (You will need a small Phillips screwdriver. ) 3. If you are using more than one remote unit, select a different channel number for each unit. Match the polarity, as shown in the battery compartment. Press RESET with the point of a blunt object (such as a ball point pen). 4 PS R01 English R15 4 7/23/03, 4:53 AM 7. 8. Replace the battery compartment lid. Mount the remote unit on a flat surface using the recess hole on the back of the unit. For best results: · Place the unit out of direct sunlight and moisture. · Do not place the remote unit more than 20 - 30 meters (60 - 90 feet) from the main (indoor) unit. · Position the unit so that it faces the main (indoor) unit. Minimize obstructions such as doors, walls, and furniture. You may need to experiment with various locations to get the best reception. Once the batteries are in place, the sensor will transmit signals approximately every 40 seconds. The readings shown on the main unit depend on which remote sensor (1, 2, or 3) is selected. Refer to the main unit User Manual for more information. CHANGE CHANNEL Repeat the Set Up procedure ( 4). In Step 3, select a different Channel Number. 5 PS R01 English R15 5 7/23/03, 4:53 AM EN EN COMFORT ZONE The outdoor comfort zones are shown under the following conditions. Zone Temperature Any Wet Any Dry 20 - 25 °C (68 - 77 °F) 40 - 70% <40% Relative Humidity TRENDS The trend arrow for the last 30 minutes always displays. Outdoor temperature and humidity trends are shown separately. Trend Temperature +0. 5 °C Steady -0. 5 °C Relative Humidity > +3% Steady < -3% >70% Comfort 6 PS R01 English R15 6 7/23/03, 4:53 AM LOW BATTERY WARNING Replace the batteries whenever the low battery signal ( ) shows on the remote unit, or on the remote unit area of the main unit. Properly dispose used batteries by taking them to an authorized disposal station. radio frequency link with main unit). [. . . ] Images not drawn to scale. TROUBLESHOOTING Check here before contacting our customer service department. Problem Temp Remote unit Symptom Main unit shows "LLL" or "HHH" Cannot locate main unit Remedy Temperature is out-of-range. Check batteries ( 4, 7) Check location ( 5) 8 PS R01 English R15 8 7/23/03, 4:53 AM SPECIFICATIONS Dimensions LxWxH 75 x 35 x 78. 3 mm (3 x 1. 4 x 3. 1 in) Weight 136 grams with battery Temperature Unit Range Resolution Frequency RF frequency Range Transmission Channel No. Unit Power 433 MHz 30 meters (98 feet) with no obstructions approximately every 40 seconds 1, 2, or 3 °C or °F 2 x UM-4 (AAA) 1. 5V alkaline batteries °C or °F -20 °C to 60 °C (-4 °F to 140 °F) 0. 1 °C (0. 2 °F) Relative humidity Range 25% to 95% Resolution 1% 9 PS R01 English R15 9 7/23/03, 4:53 AM EN EN EC-DECLARATION OF CONFORMITY This product contains the approved transmitter module TX 07 and complies with the essential requirements of Article 3 of the R&TTE 1999/5/EC Directives, if used for its intended use and that the following standard(s) has/have been applied: Radio frequency spectrum (Article 3. 2 of the R&TTE Directive) applied standard(s) ETSI EN 300 220-3 (Ver. 1. 1. 1):2000-09 Electromagnetic compatibility (Article 3. 1. b of the R&TTE Directive) applied standard(s) ETSI EN 301 489-1-3 (Ver. 1. 4. 1):2002-08 Safety of information technology equipment (Article 3. 1. a of the R&TTE directive) applied standard(s) EN 60950:2000 Additional information: The product is therefore conform with the Low Voltage Directive 73/23/EC, the EMC Directive 89/336/EC and R&TTE Directive 1999/5/EC (appendix II) and carries the respective CE marking. [. . . ]