User manual OREGON SCIENTIFIC RM313P

[. . . ] The correct time for that zone will automatically display CAUTION: Do not press and hold the ZONE button for more than three seconds. Press and release the ZONE button to advance the time zone one step. If you press and hold the ZONE button, it will deactivate the automatic time signal reception (if this happens, remove and replace the batteries to activate the radio signal receiver). Oregon Scientific Radio Controlled Projection Clock Model RM313P The split-second, precise timelines of your new Time Machine Projection Clock is achieved through its pretuned internal radio receiver that responds to a special 60kHz frequency time signal generated by the US Atomic Clock, one of the most accurate clocks in the world. [. . . ] This extraordinary timepiece, located outside Boulder, Colorado, is operated by the US Department of Commerce's National Institute of Standards and Technology. Your Time Machine Projection Clock automatically activates its receiver immediately upon battery insertion and then six times every 24 hours and makes any adjustments in its time display. It usually takes 3-7 minutes for the clock to receive the initial radio signal and adjust the time, day and date accordingly. NOTE: You may not receive a signal immediately. Due to possible interference, the best reception often occurs between midnight and 4a. m. Congratulations on your purchase of one of the first auto-setting, always accurate alarm clocks. We want you to be very happy with this clock, but please remember this is a radio wave device, and not a perfect science. There are certain areas of the eastern United States where urban interference or signals from the United Kingdom's radio control tower may distort or delay the time-setting signal. Even though these areas may have more difficulty receiving a signal, The Time Machineä contains a very accurate quartz movement and will maintain a precise time even if the radio signal is missed on occasion. The alarm will automatically arm itself. This will be indicated by the bell icon, just above the ((·)) icon on the display panel If you do not want the alarm to sound at the time you just set: Press the ON/OFF key until the bell icon disappears MANUALLY SETTING THE TIME AND DATE IMPORTANT: It highly unlikely that you should ever need or want to set these features manually; however, in the event that you should travel outside the United States and want this capability, we include these instructions. Setting the Time Press and hold MODE until the hour segment of the time flashes Press + until the desired hour appears on the LCD panel NOTE: Be sure to check the AM or PM symbol for accuracy Press MODE again until the minutes segment of the time flashes Press + until the desired minutes appear on the LCD panel Press MODE five more times to exit setting mode Setting the Year Press and hold MODE until the hour segment of the time display flashes Press MODE twice more until you see a year appear on the display Press + until the desired year appears on the display Press MODE four more times to exit the set mode and resume normal time keeping CUSTOMER ASSISTANCE Should you require assistance regarding this product and its operation, please contact our customer care department at 800-853-8883 or via email at helpme@oscientific. com. WARRANTY This product is warranted to be free of manufacturing defects for a period of 90 days from date of retail purchase. Defective product should be directed to the place of retail purchase for exchange. Should this not be possible, contact our customer care department for assistance and a return material authorization. No returns may be made without a return authorization. Please retain your retail receipt as you may be asked to provide a copy of it for proof of date purchased. [. . . ] No returns may be made without a return authorization. Please retain your retail receipt as you may be asked to provide a copy of it for proof of date purchased. This warranty does not cover product subjected to abuse, misuse, accidental damage or tampering. ENABLING/DISABLING THE ALARM To turn the alarm on or off: Press the ON/OFF button q NOTE: If the alarm is on, the bell icon will appear in the lower left corner of the LCD. [. . . ]