User manual OREGON SCIENTIFIC RM806

[. . . ] Please refer to the Manual Setting instructions in these instructions for further information. NOTE: Pressing once advance the setting by increments of 1: holding the button down for more the three seconds will accelerate the setting to rapid advance mode. WARNING: The key also is used to reactivate the signal reception process should it become disable. Please see the Trouble Shooting section for further information. [. . . ] This Bell [ [BATT] Low Battery Indicator (Figure A. 13) This [BATT] icon indicates that it is time to change batteries. Please refer to the Battery Replacement Section of this manual. Reset Button(Figure A. 14) To clear all user-selected settings and to cause the settings to default to their original values, press RESET with a blunt stylus. The reset button is located under the battery compartment door. BATTERY INSTALLATION Your Radio Controlled Clock is shipped with two AAA batteries. These batteries should last for approximately one year depending on the amount of your use of the HiGloTM backlight. Open the battery compartment, door and remove the two protective plastic strips from the batteries and slide the battery compartment door back into place. Radio Controlled Clock: The RM806 will automatically synchronize current time and date with the signal broadcast by the US Atomic Clock when the product is in reception range of the signal. When the unit is new and just out of the box, synchronization with the U. S. The unit will receive the most dependable and interference free signal automatically between Midnight and 4 AM. When the unit is receiving radio signal, the reception icon will start to blink. The reception icon will show either strong, weak or no signal depending on the strength of the radio signal. A complete reception generally takes about 2 to 5 minutes. 6 - Strong - Weak - No signal - Receiving When the reception is completed the reception icon will stop blinking. The reception icon will show [ ] for no Reception or [ ] for successful reception. For best signal reception, place the RM806 away from other equipment that emit RF or microwave signals such as TV's, radios, PC's or microwave ovens. Other causes for signal interference include electrical power transmission towers, steel reinfoced concrete construction, and/or metal siding. You may need to reposition the clock for maximum reception. Radio Frequency appliances and radios, such as the Radio Controlled Alarm Clock, perform best when placed near a window. After receiving the initial signal, updates are accomplished with greater ease. Even though there are areas that may have more difficulty in receiving a signal, the RM806 Alarm Clock contains very accurate quartz movement and will retain precise time even if a signal is missed on a rare occasion. SETTING THE ALARM 1) Press and hold the ((·)) 24h OFF button for at least three seconds. The "Hour" Segment of the alarm time will begin Flashing. 2) While the "Hour" segment is flashing press the [+] button to set the desired hour time (please note the AM/PM designation). [. . . ] o Increase the separation between the equipment and receiver. 11 GB GB o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. o Consult the dealer of an experienced radio/TV technician for help. Address: 19861 SW 95th Place, Tualatin, Oregon 97062, USA Telephone Number: 1-800-853-8883 Name and model number of the product: RADIO CONTROLLED TRAVEL CLOCK WITH Higlo BACKLIGHT CUSTOMER ASSISTANCE Should you require assistance regarding this product and its operation, please contact our customer care department at 800-853-8883 WARRANTY This product is warranted to be free of manufacturing defects for a period of 90 days from date of retail purchase. [. . . ]