User manual OREGON SCIENTIFIC RM822

[. . . ] Press [ ON / OFF ] again, alarm-time 2 is displayed and indicated by [ 2 ]. To enable the RF funciton: Press [ ] and hold for 3-seconds. The radio-reception signal will appear and a signal search will automatically commence. SETTING AN ALARM TIME To set an alarm time: 1. Set the alarm time DESCRIPTION OF PARTS [FIG. [. . . ] To unlock the unit, slide the [ ] switch to the unlocked position. The unit must be unlocked before activating any keys. Setting Alarm Two - Enter alarm-2 setting mode and follow instructions as for alarm 1. ABOUT ALARM SOUND The four-step crescendo function allows the alarm to start off gently and step up its intensity four times every 20 seconds. Without interruption, the alarm will activate for a total of two minutes. If a second alarm activates when the first alarm is sounding, the first alarm will be automatically disabled. To stop an alarm sound: - To stop the alarm, press [ ], the alarm will stop and will activate at the same time the following day. - To disable the alarm, press [ ON/OFF ], the alarm will stop and it is not active, it will not activate the following day. CALENDAR CLOCK DISPLAY MODES The RM822 /RM823 supports four display modes in the sequence of: MODE 1 Local Time Hour, Minute, Seconds ------------------------------------------Day, Month MODE 2 Local Time Hour, Minute, Day-of-the-Week ------------------------------------------Day, Month MODE 3 Local Time / Second Time-Zone Time ( localtime ) Hour, Minute, Day - of - the - Week ------------------------------------------( Second time - zone time ) Hour, Minute MODE 4 Second Time-Zone Hour, Minute, Day-of-the-Week ------------------------------------------Day, Month Display description for each time / date / time-zone mode To select a different time-display mode: Press [MODE]. The display will advance in the order as mentioned above. Note: The bottom line of the display will be replaced by the alarm time if [ ] is pressed. FIG. [ ] button To lock all the key of the unit J. UP [ ] button Increases the value of a setting Initiates radio reception (Press and hold for rapids settings) K. DOWN [ ] button Decreases the value of a setting Stops radio reception (Press and hold for rapids settings) L. Battery compartment Accommodates two UM-4 or M. [RESET] button Resets the unit to its original factory settings AAAî size batteries HOW TO USE THE SNOOZE The Lite Touch feature enables you to activate the 8 minute snooze by gently rocking the RF clock backwards on its stand with the touch of your fingers. [see FIG. D] LITE TOUCH HiGloTM BACKLIGHT Using the Lite Touch feature, the display will activate for five seconds so you can see the display in the dark. [see FIG. D] HOW TO RESET THE UNIT The RESET button allows you to return all settings to its factory values, which are, 1-1 (1st of January) for date, 00:00 for time and 0:00 for alarm, which will be deactivated. The button is required only when the unit is not operating in a favorable way, such as in the rare case of a malfunction. FIG. B BATTERY INSTALLATION The unit uses two (2) UM-4 or To insert batteries: 1. Slide the battery door in the direction of the arrow. [. . . ] This process takes between two (2) and ten (10) minutes. After initial search, short periodic receptionsignal scans will commence several times a day. The antenna icon indicates the quality of reception. Steps 1. [. . . ]