User manual OREGON SCIENTIFIC RRM112A

[. . . ] F ZONE BUTTON Press to sequence through the 4 US time zones: Pacific, Mountain, Central and Eastern. G ON / OFF BUTTON Press to select Beep Alarm-On, Radio Alarm-On and Alarm-Off modes. H CLOCK BUTTON Press to switch between Clock with Seconds and Clock with Day of the Week display modes. 2 M HEADSET CONNECTOR Connection jack for optional headset. [. . . ] The unit will also save all changes and return to normal display automatically after the unit has been left idle for 1 minute. HOW TO SET THE ALARM 1. Select between Beep-Alarm-On, Radio-Alarm-On and AlarmOff mode by pressing the [ ON / OFF ] button. Hours digits AND SELECT DAY-OF-THE-WEEK DISPLAY LANGUAGE the automatic signal reception feaure is disengaged, the RRM112A can be manually set and will operate as quartz clock. To manually set the RRM-112, the clock needs to be in normal time display mode. Press [CLOCK] for two seconds and the hours digits will start flashing. Enter the hours using the VOLUME [ + ] and VOLUME [ - ] buttons. Hold down either button to rapidly increase or decrease the value. Enter the minutes using the VOLUME [ + ] and VOLUME [ - ] button. Use VOLUME [ + ] / [ - ] to enter the hours. Use VOLUME [ + ] / [ - ] to enter the minutes. If the Radio Alarm-On mode has been selected, press [AM / FM] to select the correct frequency and then [STATION] to select the radio station. Use VOLUME [ + ] / [ - ] to set the volume. In Beep Alarm-On mode, a 2-minute crescendo alarm will sound when alarm is active. In Radio Alarm-On mode, the radio will remain on for 2-hours before turning off automatically if not manually deactivate. GB GB Note: Steps 7~10 will not operate if there is no battery for the radio. To change the volume, use VOLUME [ + ] / [ - ] . To select a programmed channel, press [STATION] To turn off the radio, press [RADIO]. HOW TO USE THE ALARM Press the[ ON/OFF]. To activate or deactivate an alarm, when the alarm is not active the [ ] will not be displayed. AUTO SEARCH FUNCTION The RRM112A is equipped with the Auto Search function; the unit will automatically search for the next clear channel. Press and hold TUNING [ function, ] /[ ] to activate the auto search SNOOZE FUNCTION When the snooze function is activated, the alarm will be muted temporarily and set off again after eight minutes. To disable the snooze function, press [ ON/OFF]. Note: The snooze function will only operate in Beep-Alarm mode. The snooze function will not operate in the Radio-Alarm mode. 2. The frequency increases or decreases until a clear channel is found. Note: User may release the key during the tuning process SECTION 3 THE RADIO HOW TO PROGRAM A CHANNEL HOW TO USE THE RADIO To turn on the radio, press [RADIO]. [. . . ] · Do not wear headphones wihile driving or cycling, doing so may prevent you from hearing important information or traffic sounds. · You should use extreme caution or temporarily discontinue use in potentially hazardous situations, such as walking, jogging, etc. · Wear them properly; L is left, R is right. · The headphones should be worn with the longer cord behind your neck. Memory station Battery type Weight Dimension : 8 selections for AM 8 selections for FM : 2 UM-3 or "AA" 1. 5V for Clock 2 UM-3 or "AA" 1. 5V for Radio : 286. 8 gm 10. 03 ounces : 132 x 158 x 23 mm (H x W x D) 5. 28" x 6. 32" x 0. 92" NOTE ON COMPLIANCE Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ]