User manual OREGON SCIENTIFIC SL928M

[. . . ] [ SEGMENT ] INDICATOR Indicates the number of segments in a counting K. [ ] INDICATOR Indicates the AUTO LIGHT function is active ] INDICATOR L. [ ] INDICATOR Indicates the split time N. [ ] INDICATOR Indicates the CHRONO mode ] INDICATOR O. [. . . ] The stopwatch can register up to 500 laps. Press [LAP] after stopping to clear the display and register another segment. The stopwatch can register up to 99 segments. 99 segments share with total 500 lap memories. The effective memory left for laps will be reduced as the number of registered segments increase. The free memory remained will be shown on the display when a segment is registered. Chronograph mode can be run at the background when the stopwatch is started and go to the other display mode. Stopwatch function operates even, if all segment and lap memory is used up. HOW TO SELECT THE CHRONOGRAPH IN UNITS OF HOURS, MINTUES OR SECONDS Refer to (FIG. Four different chronograph units of display: hour:minute:second with 1/100 sec. resolution; hour with 1/100000 hr resolution and minute with 1/1000 min resolution. Different segment can have different chronograph unit of display. Within each segment it is allowed only one single unit of display. HOW TO RECALL CHRONOGRAPH RECORDS Refer to (FIG. The last recorded segment will be displayed with its time and date stamp when advance from chronograph mode. Two beeping sounds will be heard to indicate the end of lap record for each segment. HOW TO ERASE CHRONOGRAPH RECORDS Refer to (FIG. Note: The record of the current running chronograph cannot be deleted. 4 HOW TO USE THE TIMER Refer to (FIG. There are three modes of operation that can be chosen : CS (count down and stop), CU (count down and count up) or CR (count down, automatic reload and repeat). The maximum count down or count up time is 23 hours, 59 minutes and 59 seconds. A pre-alert tone will be emitted at five second before completion of a count cycle and an alert tone will be emitted for 10 sec. Press any button to mute the alert tone. Once started the Timer can be running in the background even if the unit is in a different display mode. HOW TO USE THE PACER Refer to (FIG. Pacer range from 30 to 240 at five-step intervals, i. e. number of beeping sound to be heard will be range from 30 beep per minute to 240 beep per mintue. [. . . ] No returns may be made without a return authorization. Please retain your retail receipt as you may be asked to provide a copy of it for proof of date purchased. This warranty does not cover product subjected to abuse, misuse, accidental damage or tampering. Upon return of the defective product, Oregon Scientific will at its discretion, replace the product with either a new or a tested reconditioned product. [. . . ]