User manual OREGON SCIENTIFIC SL928M-E

[. . . ] [ SEGMENT ] INDICATOR Indicates the number of segments in a counting K. [ ] INDICATOR Indicates the AUTO LIGHT function is active ] INDICATOR L. [ ] INDICATOR Indicates the split time N. [ ] INDICATOR Indicates the CHRONO mode ] INDICATOR O. [. . . ] The stopwatch can count up to 23 hours, 59 minutes and 59. 99 seconds before starting from zeros again. The last lap number will appear and the LAP and SPLIT time display will freeze for 5 seconds. The [ ] indicator will flash indicating the stopwatch is still running in the background. Repeat the last three steps to register other laps. The stopwatch can register up to 500 laps. Press [LAP] after stopping to clear the display and register another segment. The stopwatch can register up to 99 segments. 99 segments share with total 500 lap memories. The effective memory left for laps will be reduced as the number of registered segments increased. The free memory remained will be shown on the display when a segment is registered. Chronograph mode can be run at the background when the stopwatch is started and go to the other display mode. Stopwatch can still be operated of all segment or lap memory is being used up. HOW TO SELECT THE CHRONOGRAPH IN UNITS OF HOURS, MINTUES OR SECONDS Refer to (FIG. Four different chronograph units of display: hour:minute:second with 1/100 sec. resolution; hour with 1/100000 hr resolution and minute with 1/1000 min resolution. Different segment can have different chronograph unit of display. Within each segment it is allowed only one single unit of display. HOW TO RECALL CHRONOGRAPH RECORDS Refer to (FIG. The last recorded segment will be displayed with its time and date stamp when advance from chronograph mode. Two beeping sounds will be heart to indicate the end of lap record for each segment. HOW TO ERASE CHRONOGRAPH RECORDS Refer to (FIG. Note: The record of the current running chronograpy cannot be deleted. 4 HOW TO USE THE TIMER Refer to (FIG. There are three modes of operation can be chosen : CS (count down and stop), CU (count down and count up) or CR (count down, automatic reload and repeat). The maximum count down or count up time is 23 hours, 59 minutes and 59 seconds. A pre-alert tone will be emitted at five second before completion of a count cycle and an alert tone will be emitted for 10 sec. [. . . ] Should you need to change the battery, 1. Insert the battery strictly according to the polarities shown therein. Note: Change the battery when the display becomes dim. PRECAUTIONS This unit is engineered to give you years of satisfactory service if handled carefully. Do not clean the unit with abrasive or corrosive materials. [. . . ]