User manual OREGON SCIENTIFIC TR118

[. . . ] Turn off by pressing the START/STOP button. The other channel alarm will sound at the completion of cycle, and the indicator will count up. Press START/STOP button to turn off. 2. 5. DUAL-TIMER T1 CLOCK 6. T2 7. H M S C CLEAR START STOP MEMORY 8. TIMER MEMORY RECALL BATTERY COVER MAGNET 1. [. . . ] Timer memory recall for each count-down timer. Individual buttons for HOUR, MINUTE and SECOND setting. BATTERY REPLACEMENT To replace exhausted battery, slide push the battery cover on backside in direction of arrow. Insert a now 1. 5V `AAA' battery as indicated by the polarity symbols (+&-) marked and close battery cover. Sometimes the timer may not activate after installing a new battery. If this happens, simply remove battery from the battery compartment and reinstall again. The Clock will resume normal operation. CLIP ATTACHMENT The timer can clip on thin board, belt or shirt pocket using the plastic clip on the backside of timer. MAGNETIC ATTACHMENT NORMAL TIME SETTING 1. Press the Clock button down for approximately 3 seconds. The digits and colon will flash on the display. Press the Hour button to advance to the correct hour. Hold button down for approximately 2 seconds for fast setting. A "P" will appear on the display below the colon for PM. Press MIN button to advance to the correct minute. Hold the button down for approximately 2 seconds for fast setting. Press the SEC button to reset second digit to zero when the second digits are within the 00-29 second range; pressing SEC button in 30-59 second range advances minute setting by 1 minute and resets second digits to zero. The Clock operates independently of the timing channels. Whenever the clock button is pressed, the time of day will appear on the display. If timers are operating, T1 or T2 respectively will flash. The timer can attach to iron or steel surface, using the magnet attached to the clip on the backside of the timer. TABLE TOP USE Use the clip and metal stand bar together to stand the clock/timer at an angle on any flat surface. SPECIFICATIONS Power: use 1 pc UM-4 or "AAA" 1. 5V battery Weight: 0. 18 lbs (without battery) Dimension: 2. 75" x 0. 75" x 2. 5" (LxWxT) 6. 7. CAUTION The content of this manual is subject to change without further notice. Due to printing limitation, the displays shown in this manual may differ from the actual display. [. . . ] No returns may be made without a return authorization. Please retain your retail receipt as you may be asked to provide a copy of it for proof of date purchased. This warranty does not cover product subjected to abuse, misuse, accidental damage or tampering. Upon return of the defective product, Oregon Scientific will at its discretion, replace the product with either a new or a tested reconditioned product. [. . . ]