User manual OREGON SCIENTIFIC TR119

[. . . ] Switch the TIMER/CLOCK slide switch to TIMER position. Set the desired count-down time by using the same procedure as countdown Timer setting. Press START/STOP button once to start the count-down Timer. When Timer counts down to 0 HR 00 MIN 00 SEC ( 0:00 00 will show on display ). [. . . ] Timer alarm sounds for 1 minute when Timer counts down to zero. Sound warning for the last one minute. SECOND Press SET button (beep sound) and at the same time press SEC button (beep sound) will reset second digits to zero when second digits are within 0-30 sec. When second digits are within 31-59 sec. range, press SET and SEC button will reset second digits to zero and minute digit will advance by 1. REPLACEMENT OF BATTERY Follow the arrow direction, slide push to open the battery cover at back side of Timer. Remove exhausted battery, insert a new 1. 5V `AAA' Battery as indicated by the polarity symbols (+&-) mark and close battery cover. CLIP ATTACHMENT The timer can clip on a thin board or shirt pocket by using the plastic clip on the backside of timer. MAGNETIC ATTACHMENT The timer can attach to iron or steel surface, using the magnet attached to the clip on the backside of the timer. COUNT-DOWN TIMER SETTING 1. Switch the TIMER/CLOCK slide switch to TIMER position, 0:00 00 and TIMER mark will show on display. Press HOUR button to advance hour digits. With each press of the button a beep sound will be heard. Press and hold HOUR button for 2 seconds will fast set the hour digits. Press MIN button to advance minute digits. With each press of the button a beep sound will be heard. Press and hold MIN button for 2 seconds will fast set the minute digits. Press SEC button to advance second digits. With each press of the button a beep sound will be heard. If setting is not the desired one, press CLEAR button once to reset Timer to zero and set time again. TABLE STANDING The Timer can stand on table surface by flipping out the metal stand bar on the back side of Timer. SPECIFICATIONS Power: use 1 pc UM-4 or "AAA" 1. 5V battery Weight: 0. 22 lbs (without battery) Dimension: 2. 75" x 0. 75" x 2. 5" (LxWxT) 3. 4. 5. CAUTION The content of this manual is subject to change without further notice. Due to printing limitation, the displays shown in this manual may differ from the actual display. The contents of this manual may not be reproduced without the permis sion of the manufacturer. COUNT-DOWN TIMER START/STOP 1. After time setting is ready, press START/STOP button once and Timer will start to cound down at 1 second resolution. When Timer is counting, press START/STOP button once and Timer will stop. [. . . ] The word "MEMORY" will flash on the display. Pressing START/STOP button 2nd time can start Timer and Timer will count down for another lap. The word "MEMORY" will flash on the display. 2. COUNT-UP TIMER SETTING 1. When timer is in resting stage ( 0 HR, 00 MIN, 00 SEC ). [. . . ]