User manual OREGON SCIENTIFIC VR368

[. . . ] The available time left for recording is displayed at the bottom. The recorder then automatically returns to normal operation. To change the VOX mode: When VOX, or voice activated recording, is set to on, the recorder will stop recording when it detects several seconds of silence. [. . . ] The indicator light above the LCD turns red. To record, you can use either the internal microphone or you can plug an external microphone in to the Mic socket on the top of the recorder. For best results, keep a distance of 10 cm (min. ) to 30 cm (max. ) between the microphone (internal or external) and the sound source. To stop recording, simply press Rec again. Del Hold on/off Volume dial Marking an index during recording You can mark an index when you are recording. This means you can play back the message from the location of the index instead of having to start right at the beginning. To mark an index, simply press the Jog dial once while recording. An index will be located at the next message number during recording. Installing the batteries The VR368 digital recorder uses two 1. 5 V AAA alkaline batteries. To install the batteries: · Open the battery compartment by sliding the battery compartment cover on the back of the recorder in the direction of the arrow. · Place the batteries into the compartment, making sure they are inserted according to the correct polarity. · Slide the battery compartment cover back on until it clicks into place. Playback To play back a message: Use the Jog dial to scroll through the messages until you find the number of the message you want to hear. Press the Jog dial once to play back the message. The indicator light above the LCD turns green. To stop playback, simply press the Jog dial again. Replacing the batteries The remaining battery indicator shows the battery consumption as follows: Full -----------------------------------> Empty Deleting messages Scroll through the messages to find one you wish to delete by rotating the Jog dial. Press Del again to confirm the erasure of the single message, press Rec to cancel the erasure, or rotate the Jog dial to toggle from a single message to all messages. When ALL flashes in the display, press Del to confirm the erasure of all messages, or press Rec to cancel the erasure. If the battery mark immediately. flashes, replace the new batteries Turning the recorder on To turn the recorder on, simply press the On/Rec switch on the front. The recorder switches itself off automatically if it is not operated for about two minutes. Reset If the recorder should malfunction, use a blunt point (e. g. [. . . ] 6. 5 hours' recording time, approx. 3. 5 hours' speaker playback time (at volume 5) Recording media : built-in flash memory Max. of recordings : 99 messages Effective maximum output : 54 mW (8 ohm) Frequency range : 350 - 3600 Hz Set-up mode In Set-up mode, you can set various functions on the recorder. To enter Set-up, make sure the recorder is in stop mode (not recording or playing back messages). [. . . ]