User manual OREGON SCIENTIFIC WRF108

[. . . ] 16. " " ": Displays when VOX function is set to be high. ": Displays when intercom function is enabled. (Assume the intercom accessories are used. ) NOAA WEATHER RADIO WITH 14-CHANNEL FRS Model: WRF 108 USER'S MANUAL 17. 20. " " " " ": Displays when your radio is in NOAA ON mode. [. . . ] Your radio might cause TV or radio interference even when it is operating properly. To determine whether your radio is causing the interference, turn it off. If the interference goes away, your radio is causing it. Try to eliminate the interference by: moving your radio away from the receiver calling your local service store for help If you cannot eliminate the interference, the FCC requires that you stop using the radio. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Preparation Your radio requires 4 AAA batteries for power supply. However, you can also use rechargeable batteries in the radio. To start using your radio, insert four AAA batteries into the battery compartment, noting the polarities. As soon as you connect the power, the unit will enter the clock mode and 00:00 will display on LCD. Note: Once your batteries are used up, you should replace all the four alkaline batteries with new ones. The clock will be set to 00:00 and need to be reset again. Turning On/Off Your FRS Radio Press and hold POWER/VOL button for about 2 seconds. An audible tone will be sounded to indicate your FRS radio is on. (The unit will return to the last state before turning off) The same operation will turn off the radio and return to clock mode. Adjusting Volume Volume can be adjusted to 8 levels. When your radio is turned on, momentarily press POWER/VOL button to enter into the volumeadjusting mode. Repeatedly press UP or DOWN button to adjust volume until you get a comfortable level. Press POWER/VOL button again or do not press any button for 5 seconds, the radio will exit this mode. Key Locking You can lock your radio setting to avoid accidental pressing of keys by pressing and holding MENU/KEYLOCK button for more than 2 seconds. The function is effective to all keys except the PTT key, the 2 second-press of the MONI/FUNC/NOAA button for the monitor function and the POWER/VOL key for turning off the radio. Setting VOX Pressing the UP key while holding MONI/FUNC/NOAA button can toggle between VOX on/off. If the UP key is held down for more than 2 seconds, the unit will enter the toggle mode between high and low levels of VOX control sensitivity. [. . . ] Selecting Channel and Channel Scan Function 1. Repeatedly press UP or DOWN button to select the current working channel desired. Press and hold UP or DOWN button for more than 2 seconds to enter the channel scan mode and "SC" is displayed on the LCD. The radio automatically scans through the channels and stops for about 5 seconds on each active channel. [. . . ]