User manual OREGON BAR210A

[. . . ] 2) This device must accept any interference received, including interference that may cause undesired operation. Batteries serve as back up power supply for the clock. For continuous use of LCD backlight, always plug in the adapter socket. [. . . ] If you're in the US and would like to contact our Customer Care department directly, please visit: www2. NOTE The installed CDS light sensor inside the unit will The main unit will automatically search for the outdoor sensor. The sensor reception icon in the remote sensor area shows the status: ICON DESCRIPTION Main unit is searching for sensor. This product forecasts the next 12 to 24 hours of weather. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Approved by the party responsible for compliance could void the user's authority to operate the equipment. Position the sensor close to the main unit during cold winter months. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. The adaptor socket) away from electrical devices as heat from these devices will affect accurate indoor temperature readings. / : Increase / decrease setting; activate / deactivate clock reception signal RESET: Reset unit to default settings AUTO ON / OFF: Select auto toggle mode CLOCK: Set time and display mode °C / °F: Select temperature unit and display mode Battery compartment This product is designed to synchronize its clock automatically with a clock signal. Do not subject the unit to excessive force, shock, dust, temperature or humidity. [. . . ] Do not dispose old batteries as unsorted municipal waste. Collection of such waste separately for special The following information is not to be used as contact for support or sales. Please call our customer service number (listed on our website at www. [. . . ]