User manual OREGON BAR220

[. . . ] When disposing of this product, ensure it is collected separately for special treatment and not as normal household waste. Placement of this product on certain types of wood may result in damage to its finish for which Oregon Scientific will not be responsible. consult the furniture manufacturer's care instructions for information. The contents of this manual may not be reproduced without the permission of the manufacturer. [. . . ] Weather forecast icons ZONE: time zone offset : main unit batteries low / no battery MODE: toggle between time / indoor temperature / outdoor temperature displays : signal reception indicator PM: indicate PM Clock / indoor temperature / outdoor temperature IN: indoor temperature is displayed : remote sensor reception indicator / outdoor temperature is displayed · 76 oz) without battery -20°C to 60°C (-4°F to 140°F) 433 MHz 30 m (100 ft) unobstructed Approximately every 60 seconds 3 1 x UM-3 (AA) 1. If the signal is weak, it can take up to 24 hours to get a valid signal. NOTE During signal search, the weather icon will remain lit however the colour will be static and the icon will not change according to weather conditions. If signal reception is unsuccessful, place your unit next to a window, press and hold to force another signal search. Com) to learn more about Oregon Scientific products. If you're in the US and would like to contact our Customer Care department directly, please visit: www2. The settings order is: time zone offset, 12/24 hr format, hour, minute. Time zone offset sets the clock +/- 23 hours from the received clock signal time. If you have deactivated the clock signal reception, do not set a value for time zone. NOTE If you enter +1 in the time zone setting, this will give you your regional time plus 1 hour. If you are in the US (BAR220A only) set the clock to: 0 for Pacific time +2 for Central time +1 for Mountain time +3 for Eastern time Hereby, Oregon Scientific, declares that this Artisan weather station (model: BAR220 / BAR220A / BAR220U) is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientific Customer Service. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Please call our customer service number (listed on our website at www. Com), or on the warranty card for this product) for all inquiries instead. The main unit can be connected to only 1 remote sensor. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. [. . . ]