User manual OREGON EMR201

[. . . ] TIP Ideal placements for the sensor would be in any location on the exterior of the home at a height of not more than 5 ft and which can shield it from direct sunlight or wet conditions for an accurate reading. Placement of this product on certain types of wood may result in damage to its finish for which Oregon Scientific will not be responsible. Consult the furniture manufacturer's care instructions for information. The contents of this manual may not be reproduced without the permission of the manufacturer. [. . . ] 19861 SW 95th Ave. , Tualatin, Oregon 97062 USA 1-800-853-8883 NOTE The technical specifications for this product and the contents of the user manual are subject to change without notice. 1 OUT TEMP SPECIFICATIONS 2 TYPE MAIN UNIT LxWxH DESCRIPTION 66 x 27. 5 x 87. 5 mm (2. 59 x 1. 08 x 3. 44 in) 241 g (8. 5 oz) without battery -5°C to 50°C (23°F to 122°F) 0. 1°C (0. 2°F) 433 MHz 25% - 95% 1% 2 x UM-4 (AAA) 1. 5 V batteries 96 x 50 x 22 mm (3. 78 x 1. 97 x 0. 87 in) 62 g (2. 22 ounces) IN TEMP 3 Weight Temperature range 4 Resolution Signal frequency declare that the product Product No. : EMR201 Product Name: Wireless Indoor and Outdoor Thermometer with LED Ice Alert Manufacturer: IDT Technology Limited Address: Block C, 9/F, Kaiser Estate, Phase 1, 41 Man Yue St. , Hung Hom, Kowloon, Hong Kong is in conformity with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. 1. 4. Remote sensor reception indicator Outdoor temperature Indoor temperature Ice alert LED indicator Humidity range Humidity resolution NOTE Use alkaline batteries for longer usage and consumer grade lithium batteries in temperatures below freezing. SENSOR DATA TRANSMISSION To search for a sensor: Reset the unit. The sensor reception icon in the remote sensor area shows the status: ICON OUT Power BACK VIEW REMOTE UNIT (THN132N) LxWxH Weight Transmission range 30 m (98 ft) unobstructed Temperature range Power -20°C to 60°C (-4°F to 140°F) 1 x UM-3 (AA) 1. 5 V batteries 1 2 RESET C/ F OUT OUT OUT OUT OUT OUT DESCRIPTION Main unit is searching for sensor(s). The sensor cannot be found. ABOUT OREGON SCIENTIFIC Visit our website (www. oregonscientific. com) to learn more about Oregon Scientific products. If you're in the US and would like to contact our Customer Care department directly, please visit: www2. oregonscientific. com/service/support OR Call 1-800-853-8883. For international inquiries, please visit: www2. oregonscientific. com/about/international TIP The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results. °C / °F: Select temperature unit RESET: Reset unit to default settings ICE WARNING If the channel 1 sensor falls between 3°C to -2 °C (37°F to 28°F), LED indicator will flash, and will stop flashing once the temperature is out of this range. REMOTE SENSOR FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Images shown in this manual may differ from the actual display. When disposing of this product, ensure it is collected separately for special treatment. 1. 5. LED status indicator Wall mount hole Battery compartment RESET hole CHANNEL switch · · · GETTING STARTED INSERT BATTERIES 1. [. . . ]