User manual OREGON JM889NU

[. . . ] 4 Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Placement of unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Indoor temperature display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Toggling between seconds/day-of-week display . . . . . . . . . . . . . [. . . ] Caring for your Product To ensure you receive the maximum benefit from using this product, please observe the following guidelines. Do not use liquid cleaning agents, benzene, thinner, or aerosols. · Ventilation - The vents and other openings are designed for ventilation, and should not be blocked or covered. Blocking the vents can cause the product to overheat, and can damage the unit. · Repair - Do not attempt to repair the product or modify the circuitry by yourself. Contact the retailer or a qualified repairman if the product requires servicing. Only use replacement parts that are recommended by the manufacturer. 4 · Do not scratch hard objects against the LCD display as this may cause damage. GETTING STARTED Unpacking the product When you unpack your clock, make sure to keep all the packing materials in a safe place, in case you need to later transport or return it for servicing. In the box, you will find: Clock unit Batteries User manual Batteries NOTE When using the product for the first time, please note that the batteries have already been installed in the unit. To operate, locate the clear plastic battery tab inside the battery compartment and remove it. To load the batteries: Diagram Instructions 1. Locate the battery compartment. Placement of Unit You can either mount the main unit on a wall or make it stand on a flat surface. Method Table Stand Instruction Diagram The unit is already equipped with a Table Stand. Simply pull out the Table Stand and rest the main unit on a flat surface. 2. Install the batteries by matching the correct polarity. Always use the correct battery type (2 UM-3 AA-sized 1. 5V batteries). Warning: Reversing the polarity may damage the product. Wall Mount The main unit can be mounted onto a wall using a No. a) Position and nail the screw into the place where you would like to hang your main unit. b) Leave ample space between the wall and the screw head while testing to make sure the nail is secure. c) Fit the unit's Wall-Mount Recess Hole onto the screw head. NOTE Replace the batteries whenever the weak battery mark ( ) is shown, the display is dim, or the display does not illuminate when the power is on. Replace all the batteries at the same time - it is dangerous to mix old and new batteries. Contact your local waste disposal authority for instructions on how to dispose of used batteries. [. . . ] Remedy Move the unit away from any sources of interference, including other electronic devices. Place the main unit far away from PCs, phones, and other electronic equipment. Problem No Alarm Operation Not Normal Symptom Alarm does not sound. Certain functions do not perform. Check This Alarm is disabled. Device requires reset. Remedy Turn on the alarm setting. [. . . ]