User manual OREGON RT918

[. . . ] Operation is easy and no wire installation between the units is necessary. After battery installation or resetting the remote sensor will start transmitting signals to the Repeater while the Repeater will start receiving such signals accordingly. Upon successful reception of the signals from the remote sensor, the Repeater will in turn transmit the received signals to the main unit which also start searching for signals once batteries have been installed. [. . . ] to facilitate signal reception and transmission , positioning of the units on a windowsill is recommended. You may also tilt up the external antenna for better reception of signals. 3-COLOUR LED INDICATOR Shows the status of the reception and transmission of signals with different colours 4-POSITION DIP-SWITCH Selects the remote sensor by setting different combinations RESET BUTTON Press to reset the system during abnormal condition BATTERY DOOR BATTERY COMPARTMENT Accommodates three (3) pieces of UM-3 or "AA" 1. Once a remote sensor has been assigned to the Repeater, you can only change it by following these procedures: (1) Select the new remote sensor by the 4-position DIP switch (please refer to the table). INDICATEUR LED 3 COULEURS Affiche le statut de réception et de transmission des signaux avec différentes couleurs INTERRUPTEUR DIP 4 POSITIONS Sélectionne le capteur à distance en réglant différentes combinaisons COMMANDE RESET Appuyer pour ré-enclencher le système en cas de fonctionnement anormal TRAPPE DES PILES LOGEMENT DES PILES Reçoit trois (3) piles UM-3 ou AA/R6 1, 5V ANTENNE ORIENTABLE EXTERNE Pour recevoir les signaux des capteurs à distance SUPPORT MURAL Une fois qu'un capteur à distance a été attribué au Répétiteur, on ne peut le changer qu'en suivant les procédures suivantes : (1) Sélectionner le nouveau capteur à distance avec l'interrupteur DIP 4positions (se reporter au tableau). The Repeater comes with a wall-mount bracket which enables you to mount the unit on the wall. To do so, simply slide in the Repeater into the bracket and hang the unit on the wall by the wall-mount hole on the bracket. Select the correct remote sensor by entering the corresponding code with the DIP-Switch inside the battery compartment (please see table for coding combinations and instructions). When handled properly, this unit is engineered to give you years of satisfactory service. Here are a few product care instructions: 1. If the unit comes in contact with water, dry it immediately with a soft lint-free cloth. Do not clean the unit with abrasive or corrosive materials. Abrasive cleaning agents may scratch the plastic parts and corrode the electronic circuit. Do not subject the unit to excessive: force, shock, dust, temperature, or humidity. Such treatment may result in malfunction, a shorter electronic life span, damaged batteries, or distorted parts. Do not tamper with the unit's internal components. [. . . ] Position the Repeater with the remote sensor and the main display unit within the effective transmission range. - The content of this manual is subject to change without further notice. - Due to printing limitation, the displays shown in this manual may differ from the actual display. [. . . ]