User manual OREGON TR118

[. . . ] Count-up timer in alarm mode can be stopped by pressing any button. If both channels are counting down, when time expires in both channels within a minute of each other and the alarm has not been turned off, the alarm for the just expired timer will sound with the other timer channel flashing on the display. The other channel alarm will sound at the completion of cycle, and the indicator will count up. After timer buzzer alarm stops, press START/STOP button once to recall preset timer time. [. . . ] Press the SEC button to reset second digit to zero when the second digits are within the 00-29 second range; pressing SEC button in 3059 second range advances minute setting by 1 minute and resets second digits to zero. Whenever the clock button is pressed, the time of day will appear in the display. The timer can clip on thin board, belt or shirt pocket using the plastic clip on the backside of timer. The timer can attach to iron or steel surface, using the magnet attached to clip on backside of timer. Use the clip and metal stand bar together to stand clock/timer at an angle on any flat surface. When handled properly, this unit is engineered to give you years of satisfactory service. Here are a few product care instructions: 1. If the unit comes in contact with water, dry it immediately with a soft lint-free cloth. Do not clean the unit with alcohol containing detergent, abrasive or corrosive materials. Abrasive cleaning agents may scratch the plastic parts and corrode the electronic circuit. Do not subject the unit to excessive: force, shock, dust, temperature, or humidity. Such treatment may result in malfunction, a shorter electronic life span, damaged batteries, or distorted parts. Do not tamper with the unit's internal components. Doing so will terminate the unit's warranty and may cause damage. Only use new batteries as specified in this instruction manual. Do not mix new and old batteries as the old batteries may leak. Read this instruction manual thoroughly before operating the unit. To activate 24 hour format, in Clock Mode hold START/STOP button down for approximately 3 seconds, beep tone will indicate format change. [. . . ] When using both timer channels, simply press the T1 or T2 button to note count down time remaining. Non-flashing (T1 or T2) indicates the count down time of the channel being displayed. Com) to learn more about Oregon Scientific products such as digital cameras; MP3 players; children's electronic learning products and games; projection clocks; health and fitness gear; weather stations; and digital and conference phones. The website also includes contact information for our customer care department in case you need to reach us, as well as frequently asked questions and customer downloads. [. . . ]