User manual OREGON WMR200A

[. . . ] Professional Weather Center Model: WMR200 / WMR200A USER MANUAL CONTENTS Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Packaging Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Base Station . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Wind Sensor / Temperature & Humidity Sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Slide the solar panel connector into place on the other side of the bracket. Once facing desired direction, use screw to fix in place. Loosen the wing bolt and adjust the angle. Tighten wing bolt to secure solar panel at desired angle. Plug one solar panel cable into the socket. NOTE For best results, direct solar panel as follows: Solar panel facing: North South If you reside in the: Southern Hemisphere Northern Hemisphere 3. To ensure a level plane: Put a few drops of water on the cross at the base of the funnel to check the horizontal level. 6 SENSOR DATA TRANSMISSION 1 3 4 2 To search for a sensor: 1. icons will flash for 5 minutes. NOTE Unit will search only for already registered sensors or new sensors reset within last 30 minutes. To register a new sensor, reset sensor prior to search. The sensor reception icon in the remote sensor area shows the status: Water will pool to the center of the cross when the rain gauge is level. If water remains on 1-4, the gauge is not horizontal. If necessary, adjust the level using the screw. ICON DESCRIPTION Base station is searching for sensor(s) A channel has been found Sensor 1 data received The sensor cannot be found. NOTE For best results, ensure the base is horizontal to allow maximum drainage of any collected rain. TIP The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results. GETTING STARTED SET UP BASE STATION NOTE Install batteries matching the polarities (+ / -) in the remote sensor before installing the base station. CLOCK CLOCK RECEPTION This product is designed to synchronize its clock automatically with a clock signal. WMR200: Slide switch to EU / UK to select the desired signal. · EU: DCF-77 signal: within 1500km (932 miles) of Frankfurt, Germany. · UK: MSF-60 signal: within 1500km (932 miles) of Anthorn, England. WMR200A: WWVB-60 signal: within 3200km (2000 miles) of Fort Collins Colorado. Manually set clock to select time zone (Pacific, Mountain, Central or Eastern). indicates the status of the clock reception signal. ICON MEANING Time is synchronized Receiving signal is strong Time is not synchronized Receiving signal is weak NOTE Reception takes 2-10 minutes. [. . . ] Dew Point w/ Min and Max Hi / Lo INDOOR RELATIVE HUMIDITY Displayed range Operating range Resolution Accuracy 2% to 98% 25% to 90% 1% 25% - 40%: +/- 7% 40% - 80%: +/- 5% 80% - 90%: +/- 7% 40% to 70% Comfort Memory Alarm Current, Min and Max Hi / Lo EU-DECLARATION OF CONFORMITY Hereby, Oregon Scientific, declares that this Professional Weather Center (Models: WMR200 / WMR200A) is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientific Customer Service. RADIO-CONTROLLED / ATOMIC CLOCK Synchronization Clock display Hour format Calendar Weekday in 5 languages Battery Auto or disabled HH:MM:SS 12hr AM/PM or 24hr DD/MM or MM/DD (E, G, F, I, S) 4 x UM-3 (AA) 1. 5V batteries AC adapter 6V REMOTE WIND SENSOR UNIT Dimensions (L x W x H) Weight Wind speed unit Speed accuracy Direction accuracy Transmission of wind speed signal Memory Battery 178 x 76 x 214 mm (7 x 3 x 8. 4 inches) 100 g (3. 53 oz) without battery m/s, kph, mph, knots 2 m/s ~ 10 m/s (+/- 3 m/s) 10 m/s ~ 56 m/s (+/- 10%) 16 positions Approx. every 14 seconds Max speed gust 2 x UM-3 (AA) 1. 5V batteries COUNTRIES RTTE APPROVAL COMPLIED All EU countries, Switzerland CH and Norway N FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. [. . . ]