User manual ORION TELESCOPES & BINOCULARS INTELLISCOPE HOLSTER

[. . . ] SkyQuest IntelliScope Controller Holster #7882 The Controller holster gives a convenient place to put the IntelliScope controller when its is not in use. Located at the top of the IntelliScope's Dobsonian base, the holster keeps your controller out of the way while still remaining in a convenient place to grab at a moment's notice. [. . . ] Cut out the template and tape it to the top of the Dobsonian base. Make certain the curve of the template lines up with the curve of the top of the base. Also make certain that you are drilling holes on the side of the base that has the IntelliScope Computer Port. Using the drill, carefully drill pilot holes through the cross marks in the template and into the Dobsonian base. Drill only about 1/2" into the base. Remove the template from the base. Thread the two screws into the pilot holes. Do not thread them completely into the base for now. Take the holster and slide it onto the screws by the two slots on its bottom. Then tighten the two screws until they are tight against the holster. The holster should be secure and should not "wobble". If you need to remove the holster, thread the screws back a turn or two and slide the holster off of the screws. Using the Holster Once the holster is installed, simply place the hand control into the holster, making certain that the cord does not get caught between the controller and the holster. [. . . ] Cut on dotted lines. Customer Support (800) 676-1343 Email: support@telescope. com Providing Exceptional Consumer Optical Products Since 1975 Corporate Offices (831) 763-7000 P. O. Box 1815, Santa Cruz, CA 95061 IN 233 Rev B 08/03 [. . . ]