User manual OSTER OGG61403

[. . . ] · Be sure your Microwave Drawer is installed and grounded properly by a qualified installer or service technician. · Remove the feature sticker, if there is one. Oven Check the drawer for cavity any damage, such as misaligned or bent drawer, damaged drawer seals and sealing surfaces, broken or loose Microwave Drawer guides and dents inside the cavity or on the front side of the drawer. If there is any damage, do not operate the Microwave Drawer and contact your dealer or a OSTER AUTHORIZED SERVICER. Sealing surface IMPORTANT SAFETY INSTRUCTIONS If the information in this manual is not followed exactly, a fire or electrical shock may result that could cause property damage, personal injury or death. To reduce the risk of tipping, the Microwave Drawer must be secured by a properly installed Anti-Tip block. · This Microwave Drawer must be electrically grounded in accordance with local codes. [. . . ] · Observe all governing codes and ordinances. · Be sure to leave these instructions with the consumer. · Read all of the Installation Manual before installing the Microwave Drawer. Never leave children alone or unattended in the area where a Microwave Drawer is in use. Never leave the drawer open when the microwave is unattended. Stepping, leaning or sitting on the drawer may result in serious injuries and can also cause damage to the Microwave Drawer. · Do not use the Microwave Drawer as a storage space. This creates a potentially hazardous situation. · Check that the time-of-day is in the display. If not, touch Stop/Clear to prevent unintended use. 1 CLEARANCES AND DIMENSIONS · Dimensions that are shown in Figure 1 (for 24") or Figures 3 and 4 (for 30") must be used. Given dimensions provide minimum clearance. Locate electrical outlet in the shaded area in the upper left-hand corner of the cutout. Place the drawer adjacent to the wall or cabinet opening. Plug the power supply cord into the electrical outlet. Parts supplied The drawer is equipped with a 3-prong grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded. Should you only have a 2-prong outlet, have a qualified electrician install a correct wall receptacle. Note: If you have any questions about the grounding or electrical instructions, consult a qualified electrician or service person. 2. Carefully guide the drawer into the prepared opening. Avoid pinching the cord between the oven and the wall. 4 Screws Figure 8B 3. Slide the drawer all the way until the mounting flange is flush with the face of the cabinet. Using the 4 holes on the drawer as a template, pre drill the cabinet using a 1/16" bit. Secure the drawer with the 4 screws supplied. [. . . ] See Figure 8B. GROUNDING INSTRUCTIONS This appliance must be grounded. The Microwave Drawer is equipped with a cord having a grounding wire with a grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of Permanent and Correct Installation an electrical shor t circuit, 3-Prong plug grounding reduces r isk of electric shock by providing an escape wire for the electric current. [. . . ]