User manual PACKARD BELL I MEDIA 5054 CYCLOPS (I-MEDIA) DISASSEMBLY MANUAL
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PACKARD BELL I MEDIA 5054. We hope that this PACKARD BELL I MEDIA 5054 user guide will be useful to you.
Lastmanuals help download the user guide PACKARD BELL I MEDIA 5054.
Manual abstract: user guide PACKARD BELL I MEDIA 5054CYCLOPS (I-MEDIA) DISASSEMBLY MANUAL
Detailed instructions for use are in the User's Guide.
[. . . ] Only technicians authorized by NEC Computers International BV should attempt to repair this equipment. All troubleshooting and repair procedures are detailed to allow only subassembly/module level repair. Because of the complexity of the individual boards and subassemblies, no one should attempt to make repairs at the component level or to make modifications to any printed wiring board. [. . . ] Before picking up the device you (un)install, you should wear an anti-static wrist wrap (available at electronic supply stores). be sure to connect the wrist wrap to an unpainted metal portion of the computer chassis. As an alternative, you can dissipate electrostatic buildup by touching an unpainted metal portion of the computer chassis with one hand. Then touch the device you are (un)installing with the other hand, and maintain continuous contact with it until it is (un)installed in the computer. Under no circumstances should you attempt to disassemble the power supply. the power supply contains no user-serviceable parts. Inside the power supply are hazardous voltages that can cause serious personal injury. Always return a defective power supply to your dealer. Carefully slide the side panel towards the back and pull it away from the chassis. With one hand grip the notch at the bottom of the front bezel and firmly pull it away. To remove the DVD/CD-ROM drive, first open the chassis (see section Opening the Chassis) and remove the front bezel (see section Removing the Front Bezel), then follow the steps below: 1. To remove the floppy disk drive, first open the chassis (see section Opening the Chassis) and remove the front bezel (see section Removing the Front Bezel), then follow the steps below: To remove the hard disk drive, first open the chassis (see section Opening the Chassis) and remove the front bezel (see section Removing the Front Bezel), then follow the steps below: 1. Carefully disconnect the four-wire power cable and the flat data interface cable from the hard disk drive. Remove the four screws (two on either side) from the bay and take out the hard disk drive. [. . . ] If the switch is set incorrectly, the system could become seriously damaged. The information in this guide is subject to change without notice. this guide contains information protected by copyright. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PACKARD BELL I MEDIA 5054
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PACKARD BELL I MEDIA 5054 will begin.
