User manual PACKARD BELL LCD TELEVISION 20C2005-06

[. . . ] No part of this manual may be reproduced or transmitted, in any form or by any means, whether electronic, chemical, manual or otherwise, including but not limited to photocopying, recording, or information storage and retrieval systems, for any purpose without prior written permission of NEC Computers International BV. DISCLAIMER NEC Computers International BV specifically disclaims all warranties, either express or implied, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose with respect to this product and documentation. updates to hardware components are made regularly. Therefore some of the instructions, specifications and pictures in this documentation may differ slightly from your particular situation. [. . . ] To prevent any unsafe situations, no naked flame sources, such as lighted candles, should be placed on or in the vicinity. Avoid heat, direct sunlight and exposure to rain or water. Insert the aerial plug firmly into the aerial socket ANT IN at the back of the TV and connect ancillary equipment. Plug the power cord into household mains socket Do not throw your batteries into fire. Do not mix battery types or combine used batteries with new ones. Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment. If you do not intend to use the remote control for a long time, remove the batteries. There are two ways to switch the TV set to stand-by mode. The remote control can switch on the TV set if it was switched to stand-by using method (A) or method (B). Use the " ", " " button on the remote control to select the desired item, then use " ", " " to enter it, and use "MENU" to exit. From MENU TV COUNTRY, select the desired country or TV system*. Select your country, then move to "SCAN". Use "INSERT" to sort each channel on the program position of your choice. From MENU TV INSERT, press " ", " " to select the desired program position where you want the current channel to be inserted and then press "MENU". Example: To move the current channel on program 10 into program 3: · From MENU TV INSERT, use the " " button to change number to 3. The TV is never completely powered off unless it is physically unplugged. Display input source when using any other input. With this key you can set a time period after which the TV should switch itself to standby. Press the key repeatedly to select the number of minutes. the counter runs from 0 , 30 , 60 , 90 , 120 minutes. The timer begins to count down from the number of minutes selected after the display has disappeared. Select your input source: press repeatedly to select TV, AV, SVIDEO or SCART mode, according to where you connected your external source. [. . . ] Remove the back plate at the back of the TV as shown on the illustration. Lay the LCD TV with the screen down on a table, as it will be easier to connect your peripheral equipment. Please take your precautions not to damage the screen. Additional equipment and cables shown are not supplied with this TV set. [. . . ]