User manual PALM GPS 3263 GETTING STARTED GUIDE

[. . . ] The Palm® GPS Navigator provides detailed maps, route planning, and voice navigation. the GPS Navigator uses TomTom NAVIGATOR software and maps on your device. To use Navigator, your device makes a wireless connection to the included GPS receiver using Bluetooth® wireless technology. The receiver then transmits information to the NAVIGATOR software that is displayed on your device screen. [. . . ] Insert the card reader included in this package into a powered USB port on your computer. Insert the blank expansion card into the card reader. Putting maps on a blank expansion card Select your language and check the I Agree box if you agree. You must check the I Agree box to install the Select Memory card reader/writer and click the forward arrow. When the Installation complete message appears, click the arrow. To add maps to the card, see "Adding a map to the TomTom NAVIGATOR expansion card" on page 10. What is the passkey I'm asked to enter when creating a partnership between my device and the Bluetooth® GPS receiver? like a password , the passkey is a security measure. Connections can happen only between your device and a Bluetooth device that has the same passkey. the passkey for the receiver is 0000 (four zeroes). You should need to enter the passkey only the first time you establish a Bluetooth connection between your device and the receiver. My device does not seem like it successfully connected to the receiver after setup. If the setup process does not seem to work, try manually creating a partnership between your device and the receiver. Enter the four-digit passkey 0000 (four zeroes) on your device. Check the Turn on Bluetooth box if it is not already checked. Select the GPS receiver from the device list, and then press Next action key). Enter the four-digit passkey 0000 (four zeroes) on your device, and then press Finish (right action key). Should I keep my device and the receiver connected to the vehicle power adapter while they are in use?If your device is fully charged, it can run for about four to five hours in the car. For longer trips, it is a good idea to keep the vehicle power adapter connected to keep both your device and the receiver charged. This prevents the batteries from getting too low for the Bluetooth connection to function. Where can I get customer support if I need it? [. . . ] Follow the instructions in this manual carefully. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. [. . . ]