User manual PALSON ARIZONA

[. . . ] Do not place clothes or hands inside the brush or in openings on the robot as this could result in injury. Use the exclusive robotic vacuum charger only; failure to observe this warning could result in fire, electric shock or personal injury. Do not over-bend the power cable or place weight on top of it as this could damage the cable or result in electric shock or fire. Do not place the device close to cigarettes, lighters, matches or any other heat sources, including combustible materials, petrol, solvents, etc. [. . . ] All parts must be replaced following the dismantling steps in reverse order. The robotic vacuum may not locate the docking station if there is an obstruction, the battery is low or in more complex situations. The docking station should therefore be placed in a wide open space, where possible. When the robot finishes cleaning, the battery will be very hot, meaning longer charging times Do not use the mop or pull bar on rugs or uneven floors. First empty the container and then clean it using the cleaning brush. Remove the fan housing and clean the air intake/outlet using the cleaning brush. Clean the filter using a hair dryer or with the cleaning brush (See figures 5 and 6). After cleaning, put it firmly back in place as it was before dismantling. Loosen the screw in the main shaft of the side brush before changing it. Push the side brush against the main shaft and then tighten the screw. For optimum cleaning, frequently remove built-up hair and dust from the rubber and floor rollers. If you do not hear the beeps during code testing, repeat the previous steps. Operating guide Start/Stop Operating information Turn on the machine; when you press the Start/Stop button, the machine will start working, and pressing it again will turn the machine off. When you press " ", the current time number 88 will start flashing. Press any given day of the week, several days or all days to set the device to clean on any one, several days or every day of the week. Use the buttons to select your desired hour of cleaning. Use to set your desired minutes of cleaning. Cleaning Setting continuous cleaning If you have a large house, you can use function " " (continuous cleaning), in which the robotic vacuum will start cleaning when fully charged and return to the docking station automatically before its battery is flat. The robotic vacuum will start cleaning automatically when the battery is charged (charging time is about 5 or 6 hours). Note: The continuous cleaning and scheduled cleaning functions cannot be used at the same time!Error display Speed selection If you are certain that there is an error with the device, with the remote control within range, press this function button on the remote. The screen will show an error code which you should be able to clear by following instructions in the troubleshooting section. [. . . ] Space divider instructions for use and operating mode no. This difference may vary according to the current surroundings and different battery energy levels in the robot and the space divider. Troubleshooting The robot doesn't work or doesn't clean properly 1. Check that the device, filter and air intake are clean and that the side brush is working correctly. [. . . ]