User manual PALSON CITY

[. . . ] - A damaged or faulty power cord should only be replaced by the authorised technical service, as special tools are required. - The iron must be used strictly in accordance with these instructions. NO liability will be accepted for any damage caused by not following these instructions or by any incorrect use or handling. [. . . ] Children must be watched to make sure that they do not play with the appliance. - If the power cord is damaged, it must be replaced by the manufacturer or its authorised technical service or by a qualified technician in order to avoid hazards. DIRECTIONS FOR USE: STEAM IRONING Filling with water: * Move the steam adjustment control down as far as it will go. * Hold the iron vertical so that the water filling hole is horizontal. Fill with water (without additives) to the maximum level through the water filling hole. This setting can be used for most fabrics. Delicate synthetic fabrics should be ironed with the temperature selector set to the beginning of the coloured area (MIN. Steam ironing delicate synthetic fabrics: In practice, most fabrics can be steam ironed due to the barrier created by the steam between the ceramic soleplate and the fabric. The temperature control selector must be placed at the beginning of the coloured area (3 points). Topping up with water: * Unplug the iron from the mains supply. * Plug the iron into the mains and wait until the temperature lamp turns off. set the steam adjustment control to the desired level. DRY IRONING: * Move the steam adjustment control as far as it will go to the less coloured area (MIN. Move the steam adjustment control to "max" and empty any water that there may be in the tank. Then, move the steam variation control to "min" and leave the iron to cool. * When it is not being used, always stand the iron in vertical position, on its heel; this will protect the ceramic soleplate. Integral power cord storage: * For easy storage, the power cord can be wrapped around a holder. Do not pull too hard on the cord as this could damage the cord protector. [. . . ] * The iron works with a constant steam volume and this means that the steam pressure remains constant irrespective of the quantity of water in the tank. the desired steam volume is set by the steam adjustment control. * The first time that you use your iron, a small quantity of smoke may be given off. [. . . ]