User manual PALSONIC DVD3000-BASIC CONNECTION, OPTIONAL AUDIO CONNECTION, BASIC TROUBLESHOOTING

[. . . ] S-video cord (optional) Connecting to a TV with stereo sound A 1. To audio input connectors (red, white) 6. Power cord to power outlet (AC 110-240V, 50/60 Hz) (See A mentioned above) Note: When the above connection is made, you must change "CNTR and REAR SPEARER" , "SUBWOOFER" setting to "OFF". (refer to page 21) Notes: l During DVD playing, the TV volume may be at a lower level than during TV broadcast. [. . . ] l If any electrolyte should come into contact with parts of your skin, wash it off thoroughly with water. Remote control unit operating range Point the remote control unit no more than 7m from the remote control sensor and about 60 of the front of the unit. AMPLIFIER CENTER AUDIO FRONT AUDIO(L) FRONT AUDIO(R) SURROUND AUDIO(L) SURROUND AUDIO(R) SUBWOOFER AUDIO l Remote control preparation Battery installation: Insert the batteries while observing the correct (+) and (-) polarities as illustrated below. Service life of batteries: l The batteries depend on how often and for what operations the remote control unit is used. l If the remote control unit fails to work even when it is operated near the player, replace the batteries. l Use batteries size #7 Notes: l Do not use rechargeable (NiCd ) batteries. l Do not attempt to recharge or short-circuit the batteries. l Do not drop, step on or impact the remote control unit. Otherwise this may damage the parts or lead to malfunction. l If the remote control unit is not going to be used for a long time, remove the batteries. Otherwise, Notes: l Do not point bright lights at the remote control signal sensor. l Do not place objects between the remote control unit and the remote control signal sensor. l Do not use this remote control unit while simultaneously operating the remote control unit of any other equipment. Troubleshooting Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation. Symptom(Common) No power Play fails to start even when " " (confirm /play) is pressed. Play commences but then stops immediately. Remedy Insert the power plug securely into the power outlet. Condensation has formed: wait about 1 or 2 hours to allow the player to dry out. This player cannot play discs other than DVDs, VCDs and audio CDs. The disc may be dirty and require cleaning. Ensure that the disc is installed with the label side up. Ensure that the equipment is connected properly. [. . . ] Alternatively, turn off the unit, disconnect the AC power cord and then re-connect it. (The player may not be operating properly due to lighting, static electricity or some other external factor. ) No picture. Distorted sound. Picture is distorted during rapid advance or rapid reverse. No operations can be performed with the remote control. No key operation ( by the unit and/ or the remote control ) is effective. Symptom[DVD] Audio soundtrack and/or subtitle language is not the one selected at the initial settings Some function fails to operate while pressing the corresponding keys. Remedy If the audio soundtrack and/or subtitle language does not exist on the disc, the language selected at the settings will not be seen/heard. [. . . ]