User manual PALSONIC HDSTB100

[. . . ] OWNER'S MANUAL HIGH DEFINITION SET-TOP-BOX MODEL: HDSTB100 N111 PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL: (02) 9313 7111 FAX: (02) 9313 7555 www. palsonic. com. au PALSONIC CUSTOMER SERVICE TELEPHONE AUSTRALIA: 1300 657 888 Table of Contents Set-up and Quick Use Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Chapter1:Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Chapter 2: Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Front and rear view of the STB . . . . . . . . . . . . . . . . . . [. . . ] 4:3 Letterbox Aspect Video formats with aspect ratios greater than 16:9 will be displayed at the proper width, so no video information is lost. Black bars will appear above and below the picture. 16:9 Sidebar Aspect 4:3 pictures will be viewed on a wide aspect TV screen with vertical bars on both sides of the picture. Cautions regarding use of remote control Do not expose the remote control to shock. In addition, do not expose the remote control to liquids, and do not place in an area with high humidity. Do not install or place the remote control under direct sunlight. The heat may cause deformation of the unit. The remote control may not work properly if the remote sensor window of the main unit is under direct sunlight or strong lighting. In such a case, change the angle of the lighting or STB, or operate the remote control closer to the remote sensor window. 5 Chapter 2: Introduction Remote control functional key list 16 PIP/VCR Switch between PIP and VCR for the secondary program display. Note: For PIP output or VCR output, you can only select one output at the same time. If PIP is selected, then VCR can not be selected; If VCR is selected, then PIP can not be selected. You can press PIP/VCR button to toggle and select one mode you desire. 17 PIP control buttons ON/OFF: to turn on/off PIP function. PR+/-: to select next/previous program for PIP. SWITCH: to swap the main and sub-pictures if the secondary display is at PIP status. Or to switch VCR program to main screen display and main program to VCR if the secondary display is at VCR status. 16 17 LIST: to display PIP (or VCR) program list. Note: when pressing PIP/VCR and PIP control buttons, within 5 seconds after corresponding OSD disappear, if you press digit buttons, DSP, ASPECT, VOLUME+/-, MUTE buttons, it will affect PIP picture (or VCR picture). The component out jacks are available when HD1 (576p), HD2 (1080i), or HD3 (720p) display format is selected. Important After you toggle the Display Format Selection Switch, you must turn off the STB and then turn on again, then the toggling can effect. 10 Chapter 3: Getting Started Connecting to a HD monitor (RGB type) Follow this diagram when connecting. Connection Antenna Rear of STB RS232 YPbPr RGB Rear of HD Ready TV Note: The YPbPr/RGB selection switch must be set to RGB. The RGB out jack is available when HD1 (576p), HD2 (1080i), or HD3 (720p) display format is selected. Important After you toggle the Display Format Selection Switch, you must turn off the STB and then turn on again, then the toggling can effect. 11 Chapter 3: Getting Started Connecting to a VCR Follow this diagram when connecting. Connections Rear of STB Note: These connections are only available when VCR is selected by pressing PIP/VCR button. Rear of VCR Connecting to an Amplifier Follow this diagram when connecting. Rear of STB RS232 OPTICAL COAXIAL Amplifier DIGITAL INPUT Connecting to an amplifier equipped with OPTICAL or COAXIAL. 12 Chapter 4: Operations Program Search You must perform the program search when using the STB at the first time. There are three ways to search programs: Quick Search, Auto Search and Manual Search. Quick Search If you live in the cities listed on the Quick Search menu, you may go ahead to select your city and start scanning all digital TV channel Signals. 1 2 3 4 5 6 7 Press MENU button to access the menu mode. Press button to select and highlight Program. Program System Password Time Quick SRCH Auto SRCH Manual SRCH Press ENTER button to enter into the Program menu. Press button to highlight Quick SRCH. Press ENTER button to enter into Quick search sub-menu. Highlight the first menu bar and use you live in. button to select the city Program System Password Time Quick SRCH Auto SRCH Manual SRCH Please Select City Adelaide Begin Cancel Move the highlight to Begin and press ENTER to start the searching. [. . . ] Press ENTER button again to enter into next level. Press button to move the highlight upward or downward and press ENTER to select your local time zone. Program System Password Time Time Zone NSW/ACT VIC QLD SA WA TAS NT 18 Chapter 5: Appendix DTV Channel Table Following is the list of DTV channels available in your area. You can check the following list for channel number and channel frequency. City Identifier Digital 7 Digital 9 Digital 10 Digital ABC Digital SBS Digital 7 Digital 9 Digital 10 Digital ABC Digital SBS Digital 7 Digital 9 Digital 10 Digital ABC Digital SBS Digital 7 Digital 9 Digital 10 Digital ABC Digital SBS Digital 7 Digital 9 Digital 10 Digital ABC Digital SBS QQQ-51 SBS-54 ABD-69 NTD-60 TN D-63 IMP-66 CTC-7 ABC-9 WIN-31 CBN-34 SBS-28 SBS-28 ABD-6 NTD-8 TN D-34 NBN-3 NEN-54 NRN-57 ABHN-5A/4B SBS-45 WIN-59 CTC-62 CBN-65 ABWN-56 SBS-53 Channel & Middle Frequency VHF 6-177. 5MHz VHF 8-191. 625MHz VHF 11-219. 5MHz VHF 12-226. 5MHz UHF 33-564. 5MHz VHF 6-177. 5MHz VHF 8-191. 625MHz VHF 11-219. 5MHz VHF 12-226. 5MHz UHF 36-585. 5MHz VHF 6-177. 5MHz VHF 8-191. 625MHz VHF 11-219. 5MHz VHF 12-226. 5MHz UHF 29-536. 625MHz VHF 6-177. 5MHz VHF 8-191. 625MHz VHF 11-219. 5MHz VHF 12-226. 5MHz UHF 29-536. 625MHz VHF 6-177. 5MHz VHF 8-191. 625MHz VHF 11-219. 5MHz VHF 12-226. 5MHz UHF 34-571. 5MHz UHF 50-683. 5MHz UHF 53-704. 5MHz UHF 56-725. 5MHz UHF 59-746. 5MHz UHF 62-767. 5MHz UHF 65-788. 5MHz UHF 6-177. 5MHz UHF 9A-205. 5MHz UHF 11-219. 5MHz UHF 12-226. 5MHz UHF 30-613. 5MHz UHF 29-536. 5MHz UHF 30-543. 5MHz UHF 31-550. 5MHz UHF 32-557. 5MHz UHF 36-585. 5MHz UHF 53-704. 5MHz UHF 51-690. 5MHz UHF 37-592. 5MHz UHF 38-599. 5MHz UHF 36-585. 5MHz UHF 37-592. 5MHz UHF 38-599. 5MHz UHF 51-590. 5MHz UHF 54-711. 5MHz Telstra Tower Black Mountain Telstra Tower Black Mountain Telstra Tower Black Mountain Telstra Tower Black Mountain Telstra Tower Black Mountain TBA TBA TBA TBA TBA Transmitter Location Main Transmitter-Mt Lofty Main Transmitter-Mt Lofty Main Transmitter-Mt Lofty Main Transmitter-Mt Lofty Main Transmitter-Mt Lofty Main Transmitter-Mt Coot-tha Main Transmitter-Mt Coot-tha Main Transmitter-Mt Coot-tha Main Transmitter-Mt Coot-tha Main Transmitter-Mt Coot-tha Main Transmitter-Mt Dandenong Main Transmitter-Mt Dandenong Main Transmitter-Mt Dandenong Main Transmitter-Mt Dandenong Main Transmitter-Mt Dandenong Main Transmitter-Bickley Main Transmitter-Walliston Main Transmitter-Carmel Main Transmitter-Bickley Main Transmitter-Bickley Main TransmitterArtarmon Main Transmitter Willoughby Main Transmitter Artarmon Main Transmitter Gore Hill Main Transmitter Gore Hill Start Date 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 1/1/2001 Adelaide Brisbane Melbourne Perth Sydney Batchelor Canberra Darwin Newcastle Mt Sugarloaf Broadcast Site Mt Sugarloaf Range Broadcast Site Mt Sugarloaf Range Mt Sugarloaf Mt Sugarloaf WIN Tower Knights Hill NTL Tower Knights Hill WIN Tower Knights Hill NTL Tower Knights Hill NTL Tower Knights Hill 6/30/2001 TBA 6/30/2001 TBA TBA TBA TBA TBA TBA TBA Wollongong Note: If you have trouble getting DTV channel's signal, please contact your local antenna installer for help. [. . . ]