User manual PALSONIC HDSTB200

[. . . ] High Definition Digital Receiver HDSTB200 PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL: (02) 9313 7111 FAX: (02) 9313 7555 www. palsonic. com. au PALSONIC CUSTOMER SERVICE TELEPHONE AUSTRALIA: 1300 657 888 User Manual Safety Information CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO AVOID THE RISK OF ELECTRIC SHOCK, DO NOT OPEN. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL ONLY. The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions In the literature accompanying the appliance. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO WATER OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK. ENSURE 240V AC POWER PLUG IN FULLY INSERTED INTO THE POWER SOCKET. CAUTION: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER WILL VOID THE USER'S WARRANTY. WARNING: TO ENSURE RELIABLE OPERATION AND PREVENT THE HS-STB FROM OVER HEATING, YOU MUST REMOVE THE PROTECTIVE PLASTIC FILM FROM THE HS-STB COVER. Important Safeguards These important safeguard messages will help ensure your enjoyment and proper use of the HD-STB and accessories. Please read them carefully before you begin to operate your HD-STB product. 1. [. . . ] If you unmark the channel in the favourite list, you cannot access the channel using "CH+ of "CH-" button. At that time, please perform the Favourite Setup and mark the Channel in the favourite list. 18 Using the MENU System From here you can adjust whole setting and function of HD-STB. If you press the MENU button, the menu screen will display. You can move up and down using UP or DOWN button in the menu system. Press OK or RIGHT button to select the items. MENU button will go back to one step back. If there is no remote control activity more than 60 sec, then all menu will automatically disappear for prevent unwanted operation. 1. User Preference From here you can adjust User Preference settings concerning your TV. Preferred Audio Type (I-II) You can select desired audio signal from broadcaster. If you select Dolby Digital and broadcaster simultaneous broadcast the Dolby Digital and MPEG audio, then your HD-STB will check up the Dolby Digital audio first and decode Dolby Digital audio. If you select Dolby Digital but broadcaster broadcast MPEG audio only, then your HD-STB will check up the Dolby Digital audio first and next select MPEG audio automatically. Also you can set up Audio Preference (I-II) with I-II button on the remote control. But this change is affected to selected channel only If you change channel or turn off the HD-STB, then default audio type be selected. 2) Press OK or RIGHT to select the User Preference menu. 4) Press UP or DOWN to select desired audio mode. 5) Press OK or RIGHT to save the selected audio mode. 6) Press MENU to exit the menu. User Preference Preferred Audio Type SD Output Aspect Ratio i-Plate Banner Duration Front Panel LED Dimmer Power Restore MPEG Dolby Digital 10 sec High Disable Preferred audio type when program contains MPEG and Dolby Digital audio 19 Using the MENU System SD Output Aspect Ratio You can select best fitting display mode for your SD TV screen. This function is available only Composite Video and S-Video output when the 16:9 source is coming from Broadcaster. The 16:9 format is the standard mode for most wide TV screens. You can select Widescreen or 4:3 Letter Box for fit your SD TV's screen. 1) Press MENU to display the menu. 2) Press OK or RIGHT to select the User Preference menu. 3) Press DOWN to select display format menu. 5) Press UP or DOWN to select desired display format. [. . . ] If you live within 5-10Km of DTV transmission towers, a combined VHF/UHF antenna should be adequate. Outside this area, separate VHF and UHF antennas provide superior reception performance. (2) A shielded diplexer that combines the separate VHF and UHF antenna signals into one signal. Depending on DTV signal conditions, some installations may instead require a VHF/UHF masthead amplifier. [. . . ]