User manual PALSONIC MODEL 2418

[. . . ] electricguess or take chances with electrical equipment of any kind-it is better to be safe than Never sorry. ABOVE ALL:- . To prevent fire or shock hazard do not expose this appliance to rain or moisture. Refer servicing to qualified service personnel. Never remove covers unless qualified to do so; this unit contains dangerous voltages. WARNING: . [. . . ] Press the PSET (PRESET ON/OFF) button on the front panel. The current band and channel position will be displayed on screen (in green). Press AUTO (AUTO PRESET) button, the appliance will search the signal of TV station in the order of VHFL, VHFH and UHF, as shown in the following, and memorise them from channel number 1 position. VHFL VHFH UHF * During presetting, the green block turns into yellow. The moving red block indicates the change of tuning voltage. When presetting is over, the channel position is set to number 1 automatically. Press PSET (PRESET ON/OFF) button to exit preset mode. NOTE: During presetting, auto presetting will be cut off if any one of STAND BY button, PRESET ON/OFF button or AUTO PRESET button is pressed. . Press PSET (PRESET ON/OFF) button to set preset mode. * If "SKIP" displays on the screen, press "SKIP" button on the front panel to exit "SKIP" mode. llllllllllllll 3. Press and hold manual tuning button "FT VHFL CH CH 8 SKIP SKIP llllllllllllll " "FT " till your desired program appears. VHFH UHF 8 VHFH VHFL VHFH UHF 4. Press PSET (PRESET ON/OFF) button to exit preset mode. The searched program station has been memorised at the present channel position. Repeat 1 ~ 4 steps to search another channel. 5 . FUNCTION: SKIP BUTTON: When CHANNEL SELECTOR button is used to select channels, the channel will be skipped if they are set to "SKIP" mode. For example: Set 2~7 channels to "SKIP" mode, the procedure of channel position increasing or decreasing. CHANNEL INCREASE CH 0 1 2 58 59 CH CH 8 CHANNEL DECREASE (REMOTE) 0 1 2 58 59 (THE APPLIANCE) . Press PSET (PRESET ON/OFF) button to set preset mode. Select a channel by using CHANNEL SELECTOR button. Press "SKIP" button, "SKIP" will be displayed on the screen to indicate that the channel is at "SKIP" mode. SKIP llllllllllllll 3 SKIP 4. Repeat 2 ~ 3 steps to skip another channel. Press PRESET ON/OFF button to exit preset mode. . VOLUME CONTROL SOUND CONTROL: Press the VOL button on the appliance or the Remote Control Unit to increase volume; the red block on the screen moves right. Press the VOL button on the appliance or the Remote Control Unit to decrease volume; the red block on the screen moves left. . [. . . ] power supply is correct when DC power supply May be station trouble. Press AV button once. Poor sound, picture OK. . Adjust CONTRAST control. Poor picture, sound OK. Snowy picture Lines picture Distorted picture Weak picture. [. . . ]