User manual PALSONIC MODEL 6138

[. . . ] OWNER'S MANUAL 61CM CORDLESS REMOTE COLOUR TELEVISION MODEL: 6138 PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL:(02)9313 7111 FAX:(02)9313 7555 www. palsonic. com. au PALSONIC CUSTOMER SERVICE TELEPHONE AUSTRALIA:1300 657 888 This equipment has been designed and manufactured to meet the highest international standards, but, like any electrical apparatus which is operated at mains voltage, care must be taken if you are to obtain the best results and safety is to be assured. This is particularly important with audio and TV equipment. DO DO read this handbook carefully and keep it handy for ready reference. ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of equipment) are properly made and in accordance with the manufacturer's instructions. [. . . ] Press STORE again to change the display to Green and make it permanent. Choose a Channel Number that is easy to remember. You will switch to that number when you want to watch the VCR. Hints and Tips: Some VCR's have a test signal and the tape is not needed. Some VCR'S have a switch for two channels, CH1 & CH2. Try them both and pick the clearest signal. Check that the VCR channel does not interfere with the other TV channels. The Audio/Video sockets on the back of the set may be used also. . . CLEAR The CLEAR button allows you to SKIP unwanted numbers so that you can tune 2, 7, 9, 10 without intermediate steps. The procedure is the same as STORE- just substitute CLEAR for STORE in the procedure: Press CLEAR, choose the number, press CLEAR again. The number attached to "CLEAR -" on the screen is then removed from the program. Another number may be cleared in the same way. To get the number back, use the STORE procedure. 5 THE CONTROL OF PICTURE AND SOUND 1. Function select the "PICTURE" button is used to select the following functions: On the Front Panel, BRIGHTNESS, COLOUR, CONTRAST, BALANCE and VOLUME in that order. Each of the functions is adjusted by means of the adjacent -/+ level control buttons. The -/+ control buttons only work while the function is displayed. On the Remote Control Unit, each function has a separate set of buttons. Adjustments ON SCREEN DISPLAY Decrease FUNCTION DISPLAY CONTRAST SATURATION BRIGHTNESS VOLUME Weak Pale Dark Low ---------------Green Bar Moves Increase press PIC(VOLUME) DOWN button press PIC(VOLUME) UP button Strong Deep Light Loud ON SCREEN DISPLAY FUNCTION DISPLAY BALANCE press PIC(VOLUME) DOWN button Low (Right Speaker) press PIC(VOLUME) UP button Low (Left Speaker) ---------- ------------ Green/Cyan Bar Moves 3. Tint control: Turn the TINT knob on the TV set to obtain correct hue reproduction. Treble control: Turn the knob on the TV set to adjust proper treble effect. Bass control: Turn the knob on the TV set to adjust proper bass effect. 6 REMOTE CONTROL UNIT The remote control unit allows almost everything to be adjusted from the armchair. DIGITAL BUTTON 16 14 TV 13 AV 12 DIGITAL SELECT RECALL 15 VOLUME UP/DOWN 5 PR (+/-) 6, 7 11 SOUND MPX SWITCHING 10 SLEEP 3 CONTRAST UP/DOWN PP 8 MUTE 9 BRIGHTNESS UP/DOWN 2 1 STANDBY 4 COLOUR UP/DOWN 17 BALANCE LEFT/RIGHT BATTERIES: 1. Remove the battery cover of Remote Control Unit. [. . . ] The R/Stereo cable is optional for Stereo and need not be used. 2. RECORDING FROM THE TV This is useful if the VCR does not have a tuner, or if the quality of the VCR tuner is not as good as the one in the TV set. . Press the TV (14) to select TV mode and choose a TV channel. Check you VCR manual for how to record Audio/Video. [. . . ]