User manual PALSONIC VCR-2110-CONNECTIONSETTING CHANNELSSETTING TIMERTROUBLE SHOOTING

[. . . ] Connect the TV and the AUDIO/VIDEO socket with the SCART cable (Not supplied). NOTE If you have tuned the VCR and TV set to different TV channels, you can only use the decoder for one of them. When both the TV and VCR receive signals simultaneously with the TV/VCR button switched to the TV mode, signal interruption occurs. When signal interruption appears on the TV screen, switch the TV/VCR button to the VCR mode in order to view the TV clearly. 1 . (see page 5) RF : Start from "Video Channel Setting". [. . . ] This function is also available in the Slow Playback and Still Frame modes. Frame Advance Each time the PLAY button is pressed while in the still mode, the picture advances one frame. . NOTES During SLOW PLAYBACK, use the buttons to move the noise bars up or down. During STILL FRAME, use the buttons to eliminate the shake of the picture screen. The audio output is muted except during normal PLAYBACK. The colour of the picture may be lost during picture search in the LP mode. If the VCR is left in the Still/Slow playback mode for more than 5 minutes, it will automatically return to the playback mode to prevent damage to the tape. A tape recorded in the LP mode can be played back, but special playback functions such as still and slow playback are not guaranteed. 4 Digital Tracking Control Auto Tracking When playback starts or the playback speed is changed during playback, the VCR enters the Auto tracking mode. At this time, the indication "DT" blinks on the multi-display for a few seconds. Auto Operation Functions Full Auto Playback (With VCR power OFF) 1. Insert a video cassette without the safety tab. The VCR is turned on and Playback of the tape starts. The tape is rewound to the beginning when it reaches the end. The tape is ejected and the VCR is turned off. Manual tracking If noise still appears (picture and sound) : Press the button during PLAYBACK until the best picture is obtained. Press the PLAY button for 2 SECONDS to return to the Auto tracking mode. !NOTE The noise on the screen may not be completely removed depending on the tape used, especially when the tape has been recorded on another VCR. Auto Playback (With VCR power ON) 1. Insert a video cassette without the safety tab. The tape is rewound to the beginning when it reaches the end. The VCR is not turned off. 1 Minute Skip . With this feature, you can skip over one minute's worth of commercials recorded on a tape. The VCR will search forward 60 seconds, then resume playback. Press the PLAY button to resume playback. Press the STOP/EJECT button to stop. !NOTE The Auto Playback or Full Auto Playback mode is released if one of the tape related buttons (FF, REW, PAUSE, STOP/ EJECT, PLAY or OPERATE) is pressed. Auto Turn on When a cassette tape with a safety tab is inserted with the VCR turned off, the VCR will be automatically turned on. Zero Return 1. Press the RESET button during RECORDING or PLAYBACK to set the counter to 0:00:00 at a scene you wish to watch again. [. . . ] An obstacle may be in the way of the operation. Something is wrong with the p-corn. The remote controller does not operate. Correct Indication does not appear in the multi-display. An Interference signal appears on the TV screen when watching Pay-TV. . The mode is not properly set. 8 V . . CAUSE The power cord is not plugged in There is no cassette in the VCR. . CORRECTION Insert it firmly Into the main power outlet. [. . . ]