User manual PALSONIC VCR2110

[. . . ] OWNER'S MANUAL VIDEO CASSETTE RECORDER VCR-2110 TABLE OF CONTENTS How to Use This Manual This instruction Manual explains how to use your VCR and in particular, how to use the remote control unit keys to control the VCR. There is an "identification of Controls" illustration on page 3 and 4. CAUTION AND CARE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-1 PREPARATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The VCR will search forward 60 seconds, then resume playback. Press the PLAY button to resume playback. Press the STOP/EJECT button to stop. !NOTE The Auto Playback or Full Auto Playback mode is released if one of the tape related buttons (FF, REW, PAUSE, STOP/ EJECT, PLAY or OPERATE) is pressed. Auto Turn on When a cassette tape with a safety tab is inserted with the VCR turned off, the VCR will be automatically turned on. Zero Return 1. Press the RESET button during RECORDING or PLAYBACK to set the counter to 0:00:00 at a scene you wish to watch again. The VCR will go into FF or REW mode until the counter setting is 0:00:00 Auto Rewind When a tape reaches its end, (except during FF, OTR, Index search / scan, and programmable timer recording), it will automatically be rewound to its beginning and the unit will switch to the stop mode. Auto Power off (Select by MODE screen, page 7) If no action is executed for 10 minutes in the STOP mode or for 10 minutes in the EJECT mode, the unit is automatically turned off to save electricity. Auto Repeat During PLAYBACK, press the No. 1 key on the remote control, then Playback of the tape will be repeated from beginning to end, and the repeat mark will be displayed on OSD. To release from Auto Repeat mode, press the No. 1 key again. E-10 Index Search Function You can easily locate the desired programme using the Index signal registered on the tape. !. Automatically When the recording is started. When a timer programme recording starts. An index signal is not registered when the VCR is in the recording pause mode and recording restarts. The INDEX search function can only work correctly if the index signals are spaced at least 3 minutes apart In the SP mode and 5 minutes apart in the LP mode. (2 speed model only) Manually Press the INDEX button at a desired point during recording. Reverse direction Current programme Forward direction Index Scan This function plays back the tape for about 5 seconds at each index signal. Press the INDEX button during the playback or stop mode. Index Search This function fast-fonvards or rewinds the tape to the point at which the selected index signal is registered, and starts playback from there. Press the INDEX button while in the playback or stop mode. INDEX -- INDEX -- 2. Press the REW button or press the FF button to search in the reverse or forward direction. 2. Press the button corresponding to the direction where your desired programme is located. Each time you press, the number decreases or increases respectively. INDEX SCAN INDEX 2 3. Press the PLAY button when the desired programme is found. Normal playbackstarts. Example: If the button is pressed TWICE . Press the REW button or press the FF button to search in the reverse or forward direction. When the point is found, playback will start automatically. ! [. . . ] The timer indicator ( ) is not displayed. Channels on the are not received when the VCR is on. A picture being recorded cannot be seen on the TV. The Playback picture is poor or absent. Press the TV/VCR button to make the "VCR indicator disappear in the VCR display. Use a cassette with a safety tab or cover the tab hole with adhesive tape. [. . . ]