User manual PANASONIC AG-710P

[. . . ] TO COMPLETELY DISCONNECT THIS EQUIPMENT FROM THE AC MAINS, DISCONNECT THE POWER CORD PLUG FROM THE AC RECEPTACLE. FCC Note: This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] (For example you can send F1 to F2. ) Put camera 1 in CAMERA mode and turn off the DV CONTROL function under the OTHER FUNCTIONS screen in the setup menus. · For menu operation (Page 66) · You can also use the menu buttons on the remote control. (Page 19) Put camera 2 in VCR mode, stop or eject the cassette tape, and then input a 1394 video signal. Put camera 2 in the file receiving mode. In the setup menus, OTHER FUNCTIONS screen, set FILE RECEIVE to YES. OTHER FUNCTIONS POWER SAVE H. P MODE USER FILE FILE TRANS FILE RECEIVE HOUR METER OFF TAPE ------YES 7 The following screen appears, so move the OPERATION lever r, select the data for transfer, and press the OPERATION lever (h). FILE TRANS SCENE SCENE ALL USER FILE TRANS SCENE (SCENE)EXECUTE ? 3 4 YES NO PUSH STILL FILE TRANS appears on the screen of camera 1 when the transfer is complete. FILE RECEIVE OK PLEASE POWER OFF appears on the screen of camera 2. · When turning off camera 2, be sure to use the power switch. Under no circumstances cut the power by disconnecting the battery or AC adapter. When a file is transferring, do not disconnect the DV (IEEE1394) cable or turn off the power of camera 2. It will not transfer correctly. · FILE TRANS NG appears on the screen of camera 1 if a problem occurs during the transfer. Check the connections and settings on both cameras. · Do not change the scene dial when RECEIVE MODE is displayed on camera 2. · The tape is cued at the next scene after showing [S1] on the screen. · Each time you press the INDEX button thereafter, [S2] and then [S3] are displayed, and the tape is cued up to the second and subsequent scenes. When the tape is cued up, playback starts from that section. (Up to nine scenes before or ahead on the tape can be specified for cue-up. /REW -V · Move the OPERATION q to return to normal playback. PLAY FF/ STILL ADV PAUSE STILL ADV INDEX STOP INDEX · Press the STOP button (g) to stop the search. · The function may not work properly if the interval between one index and the next is less than one minute. 50 -V -V Variable speed search This function enables you to change the playback speed and search for specific scenes. End search You can find unrecorded parts or the end of the last scene shot. 1 During playback, move the OPERATION lever q. SEARCH button. INDEX STOP INDEX SELECT STORE MENU SET ITEM VAR. ZOOM 1 In the setup menus, OTHER FUNCTIONS screen, END SEARCH, set the search method. REC END: Find the end of the last scene shot. Press the EVF DTL/END SEARCH button in the VCR mode. · The unrecorded parts are found, and a still picture that is about a second ahead is displayed. When in the camera mode, press and hold the EVF DTL/END SEARCH button for at least a second. [. . . ] Dust, direct sunlight (ultraviolet rays) or humidity may damage the tapes. Dust contains particles of hard minerals. These particles could burrow into the cassettes, causing damage to the video camera's heads or other parts. Make sure that all of your tapes are stored in the cases. [. . . ]